Zonet ZFS3015P User manual

All manuals and user guides at all-guides.com
all-guides.com

P
Pa ac ck ka ag ge e C Co on nt te en nt ts s
•One ZFS3015P / ZFS3018P
•One Quick Installation Guide
•One Power Adapter
ontact your local authorized reseller or the store purchased from for any items
damaged and/or missing.
T
To op p P Pa an ne el l
LED indicators
LED Status
Operation
Power Green
Steady: Power is ON
LNK/A T Green
Steady: Network cable connected and connection established
Flash: Data packets are transmitting
Off: Network cable is unplug
Diagram
a. ZFS3015P
Note: Power onnector is on the marked side of ZFS3015P
All manuals and user guides at all-guides.com

b. ZFS301 P
Note: Power onnector is on the marked side of ZFS3018P
R
Re ea ar r P Pa an ne el l
a. ZFS3015P
5 RJ-45 ports
b. ZFS301 P
8
RJ-45 ports
All manuals and user guides at all-guides.com

I
In ns st ta al ll la at ti io on n
1. onnect the provided power adapter to the Power connector of the ZFS3015P /
ZFS3018P
2. onnect your network devices to the RJ-45 ports of the ZFS3015P / ZFS3018P
with UTP/STP ategory 3/4/5 cables
C
Ca au ut ti io on n
•The switch must put on a surface that is able to hold at least 5kgs weight
•Power adapter must be connected to the switch properly and securely
•Suggested at least 10cm empty space around the unit for sufficient ventilation
and cooling
•Do not recommend to put any items on top of the switch
•ZFS3015P / ZFS3018P is not ideally to work in a high electromagnetic
environment, under direct sunlight, dust and vibrating surfaces
•Maximum distance between the switch and the end node is 100 meters
•Must use an unshielded or shielded twisted-pair (UTP/STP) ategory 5 or
better cables to ensure proper transmission
•Loss of data packet may encounter when using cable other than ategory 5
All manuals and user guides at all-guides.com

T
Tr ro ou ub bl le es sh ho oo ot ti in ng g
1. heck the power adapter and power wall-jet to make sure they are function
properly. heck if the switch is turned-ON and power LED is steady.
2. heck all cable connections between computer and the switch to make sure
they are connected properly.
3. Maximum distance is 100 meters from the switch to end nodes.
4. Link LED(s) is ON/flashing at the connected port(s) of the switch.
5. Test your computer’s network adapter to make sure it is installed and functioned
properly.
6. heck issues such as network collisions, domain limitations, and other physical
installation aspects. Make sure they all meet IEEE standard network
installation requirements, more details can be found at www.ieee.org.
7. If problem still persists, write down your software/hardware configuration and
LED error indications and contact your local retailer or the store purchased for
further assistance.
8. If the provided power adapter is missing, purchase 9V / 600mA power adapter
for replacement.
All manuals and user guides at all-guides.com