Zte SWP-A59A-QC User manual

ZTE Wireless Charger
6:3$$4&Quick Start Guide
14
EN

1
2
3
15

4
!
16

Indictor Light
Indictor Status
Green blinking
3 times
When the wireless charger is connected
to the power source normally.
Green on The phone is being charged on the
wireless charger.
Off
The wireless charger is not connected
to the power source or your phone isn’t
on the charger.
Blue blinking The wireless charger is in abnormal
status.
Specications
Product Name ZTE Wireless Charger
Model SWP-A59A-QC
Input DC 5 V & 9 V, 2.0 A
Output DC 5 V, 1 A & 9V, 1.1 A
Size 102.5*102.5*10.5 mm
Weight 80 g
Operating temperature 0°C ~ +35°C
Getting More Help
You can get help by:
•Sending an email to [email protected]
•Visiting
www.ztedevices.com
17

Warning and Notice
•Use original adapter or adapter that is authorized. Using
any unauthorized adapter may affect the performance
of the wireless charger.
•It is not recommended that using any phone protective
case, it may affect the wireless charging function.
•The wireless charger is not waterproof. Keep it dry and
store it in a shady and cool place.
•Handle the wireless charger carefully. Do not drop,
bend or strike it. Otherwise the wireless charger may be
damaged.
•Keep the wireless charger out of the reach of little
children. The wireless charger may cause an injury if
used as a toy.
•Do not disassemble the wireless charger.
•Do not use the wireless charger immediately after a
sudden temperature change. In such case dew may be
generated inside and outside the wireless charger, so
do not use it until it becomes dry.
•Use an antistatic cloth to clean the wireless charger. Do
not use chemical or abrasive cleanser as these could
damage the wireless charger. Disconnect the power
before cleaning.
•The wireless charger is only for your smart phone. Do
not put any other object on it.
18

LEGAL INFORMATION
Copyright © 2018 ZTE CORPORATION.
All rights reserved.
No part of this publication may be excerpted, reproduced,
translated or utilized in any form or by any means,
electronic or mechanical, including photocopying and
microlm, without the prior written permission of ZTE
Corporation.
Trademark
ZTE and the ZTE logos are trademarks of ZTE Corporation.
Notice
ZTE Corporation reserves the right to make modications
on print errors or update specications in this guide without
prior notice.
Version No.: R1.0
Declaration of RoHS Compliance
To minimize the environmental impacts and take more
responsibilities to the earth we live on, this document shall
serve as a formal declaration that ZTE Wireless Charger
manufactured by ZTE CORPORATION is in compliance
with the Directive 2011/65/EU of the European Parliament -
RoHS (Restriction of Hazardous Substances) with respect
to the following substances:
1. Lead (Pb)
19

2. Mercury (Hg)
3. Cadmium (Cd)
4. Hexavalent Chromium (Cr (VI))
5. Polybrominated biphenyls (PBBs)
6. Polybrominated diphenyl ethers (PBDEs)
ZTE Wireless Charger manufactured by ZTE
CORPORATION meets the requirements of Directive
2011/65/EU.
Disposal of Your Old Appliance
1. When this crossed-out wheeled bin
symbol is attached to a product, it means
the product is covered by the European
Directive 2012/19/EU.
2. All electrical and electronic products
should be disposed of separately from the
municipal waste stream via designated
collection facilities appointed by the
government or the local authorities.
3. The correct disposal of your old appliance
will help prevent potential negative
consequences for the environment and
human health.
For this product’s recycling information based on WEEE
directive, please send an e-mail to [email protected]
20

FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes or modications not expressly approved by the
party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for
help.
21

ZTE CORPORATION
NO. 55, Hi-tech Road South, Shenzhen, P.R.China
Postcode: 518057
22
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 15cm between the
radiator & your body.