3xLogic V250 Hybrid User manual

Package Contents Before You Begin
1. Connect all IP cameras to PoE Camera Switch with Cat5, Cat5e, or Cat6
networking cable.
2. Connect all analog cameras.
3. Connect the Corporate LAN Port to your Site LAN.
4. Connect a monitor to either HDMI or VGA (only one will func on at a  me).
5. Connect your mouse and keyboard (included) to any of the three rear USB
ports.
6. Connect power.
a. The V250 will automa cally power on and boot into a Wizard which will
guide you through the confi gura on of your video recorder.
PART NAME FUNCTION
1Power Shows the Power On/Off Status
2 HDD Blinks to indicate usage of the Hard Drive
3 Link Shows Network Connec vity
4 Tx/Rx Blinks to indicate network usage
5USB USB 2.0 port
1 2 3 4 5
DVR
POWER CABLE
RACK MOUNT EARS
MOUSE
KEYBOARD
TERMINAL BLOCK (FOR ALARMS)
Ge ng Started | V250 Hybrid
Quick Start Guide

PART NAME FUNCTION
1 Corporate LAN Port Connect to Site LAN
2 RS-232 Serial Communica ons Port
3 Audio Out Connect to Speakers
4 Alarm I/O Connect to Terminal Block
5USB 3.0 Connect External Storage for Export
6USB 2.0 Connect Mouse and Keyboard
7 HDMI/VGA Connect to Monitor
8 Audio In Bring in Audio Through Mic
9 Internal PoE Switch Connect to IP Cameras
10 Server Power Toggle Power to Appliance Only
11 Power Power to the Appliance
12 PoE Power Toggle Power to PoE Switch and Appliance
13 Analog Inputs Connect to Analog Cameras
14 Looping Analog Outputs Loop Video to an Output
15 RCA Jack In Bring in Audio
679
4
8
4
3
2
POS
110
12
5
USB DRIVE
11
Back Panel Connec on Diagram | V250 Hybrid
10385 Westmoor Drive, Suite 210, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
© 2016 3xLOGIC, Inc. All rights reserved. Informa on in this document is subject to change without no ce. 3xLOGIC and the 3xLOGIC logo are trademarks of
3xLOGIC, Inc. All other trademarks are the property of their respec ve owners. Revised: December 5, 2016 9:55 AM V1
13
15
14
NOTE:
A USB drive containing the 3xLOGIC Support
Environment has been placed in the chassis. To access
the Support Environment, open the chassis, remove
the drive, and plug it into an open USB port and boot
to the drive.
The Support Environment allows for Windows images
to be taken or applied, as well as mul ple diagnos c
tools.