8 STREME 7310 User manual

New Square swivel
Transformer not connected to Power
.-
Transformer not connected to power socket
= no light on the transformer and
no light on swivel
Transformer connected to Power -Cleaner OFF
.-
Transformer connected to power socket but
cleaner is OFF
= blue light on the transformer and
no light on swivel
7310 / 7320

Transformer connected to power socket and
cleaner is ON
= blue light and continuous red light on the
transformer and blue light on the swivel +
green light when the pump of the cleaner
is working. When the pump stop (software
programming) then the blue light stay on
but the green light is off (so t is not a
continuous green light when the cleaner is
working).
Transformer connected to Power - Cleaner ON
On the transformer
Blue light = transformer connected to power
source.
red light after pressing the top button is
showing that low voltage output is working
For Diagnostic
On the swivel
Blue light = electricity is arriving from the
transformer (cleaner must be turned on by
pressing the ON button on the transformer).
This means transformer cable and swivel entry
is OK
Green light = is indicating that the pump is
working. If during the cycle because of
programming the pump is off then the green
light turn out too

On the output of the swivel if you disconnect
the cord going to the cleaner
Turn On the cleaner
Red light is showing that the low voltage is
going thru the swivel.
So the transformer is OK, the cord between
the transformer and the swivel is Ok and the
swivel is OK
On the output of the swivel if you disconnect
the cord going to the cleaner
if you turn On the cleaner and if the blue light
is On but there is no red light at the output,
this means the transformer is OK, the cord
between the transformer and the swivel is OK
but the swivel is defective (power in is OK but
no power out)
Automated Environmental Systems Ltd., Unit 1, 1 Wimbledon Avenue, Brandon, IP27 0NZ
01842 819130 | [email protected]