Aaeon AOP-8060 User manual

AAEON Operator Panel
AOP-8060
AOP-8060 Series User Manual 1
AOP-8060
SiS 550 SoC 200MHz Processor
Based Fanless Operator Panel PC
with 5.7” STN LCD
AOP-8060 Manual 1st Ed.
Sep. 2004

AAEON Operator Panel
AOP-8060
AOP-8060 Series User Manual 2
Copyright Notice
This document is copyrighted, 2004. All rights are reserved. The original
manufacturer reserves the right to make improvements to the products described
in this manual at any time without notice.
No part of this manual may be reproduced, copied, translated, or transmitted in
any form or by any means without the prior written permission of the original
manufacturer. Information provided in this manual is intended to be accurate and
reliable. However, the original manufacturer assumes no responsibility for its use,
nor for any infringements upon the rights of third parties, which may result from
its use.
The material in this document is for product information only and is subject to
change without notice. While reasonable efforts have been made in the
preparation of this document to assure its accuracy, AAEON, assumes no
liabilities resulting from errors or omissions in this document, or from the use of
the information contained herein.
AAEON reserves the right to make changes in the product design without notice
to its users.

AAEON Operator Panel
AOP-8060
AOP-8060 Series User Manual 3
Acknowledgments
Award is a trademark of Award Software International, Inc.
VIA is a trademark of VIA Technologies, Inc.
IBM, PC/AT, PS/2 and VGA are trademarks of International Business Machines
Corporation.
Intel and Pentium are trademarks of Intel Corporation.
Microsoft Windows ® is a registered trademark of Microsoft Corporation.
RTL is a trademark of Realtek Semi-Conductor Co., Ltd.
ESS is a trademark of ESS Technology, Inc.
UMC is a trademark of United Microelectronics Corporation.
SMI is a trademark of Silicon Motion, Inc.
Creative is a trademark of Creative Technology LTD.
All other product names or trademarks are properties of their respective owners.

AAEON Operator Panel
AOP-8060
AOP-8060 Series User Manual 4
Packing List
Before you begin installing your card, please make sure that the following materials
have been shipped:
•1 AOP-8060 series Fanless Panel PC
•1 CompactFlash storage card
•1 PS/2 Y type keyboard / mouse cable
•1 CD-ROM for manual (in PDF format) and drivers
If any of these items are missing or damaged, contact your distributor or sales
representative immediately.

AAEON Operator Panel
AOP-8060
AOP-8060 Series User Manual 5
1. Use a 3 V @ 220 mA lithium battery
2. Packing: please carry the unit with both hands, handle with
care
3. Maintenance: to properly maintain and clean the surfaces, use
only approved products or clean with a dry applicator
4. CompactFlash: Turn off power before inserting or removing
CompactFlash storage card.

AAEON Operator Panel
AOP-8060
AOP-8060 Series User Manual 6
Safety & Warranty
1. Read these safety instructions carefully.
2. Keep this user's manual for later reference.
3. Disconnect this equipment from any power outlet before cleaning. Do not use
liquid or spray detergents for cleaning. Use a damp cloth.
4. For plug-in equipment, the power outlet must be installed near the equipment
and must be easily accessible.
5. Keep this equipment away from humidity.
6. Put this equipment on a reliable surface during installation. Dropping it or
letting it fall may cause damage.
7. The openings on the enclosure are for air convection. Protect the equipment
from overheating. DO NOT COVER THE OPENINGS.
8. Make sure the voltage of the power source is correct before connecting the
equipment to the power outlet.
9. Position the power cord so that people cannot step on it. Do not place
anything over the power cord.
10. All cautions and warnings on the equipment should be noted.
11. If the equipment is not used for a long time, disconnect it from the power
source to avoid damage by transient over voltage.
12. Never pour any liquid into an opening. This may cause fire or electrical shock.
13. Never open the equipment. For safety reasons, the equipment should be
opened only by qualified service personnel.

AAEON Operator Panel
AOP-8060
AOP-8060 Series User Manual 7
14. If one of the following situations arises, get the equipment checked by
service personnel:
a. The power cord or plug is damaged.
b. Liquid has penetrated into the equipment.
c. The equipment has been exposed to moisture.
d. The equipment does not work well, or you cannot get it to work
according to the users manual.
e. The equipment has been dropped and damaged.
f. The equipment has obvious signs of breakage.
15. DO NOT LEAVE THIS EQUIPMENT IN AN UNCONTROLLED
ENVIRONMENT WHERE THE STORAGE TEMPERATURE IS
BELOW -20° C (-4°F) OR ABOVE 60° C (140° F). IT MAY DAMAGE
THE EQUIPMENT.
16. CAUTION: DANGER OF EXPLOSION IF BATTERY IS
INCORRECTLY REPLACED.REPLACE ONLY WITH THE SAME OR
EQUIVALENT TYPE RECOMMENDED BY THE MANUFACTURER,
DISCARD USED BATTERIES ACCORDING TO THE
MANUFACTURER'S INSTRUCTIONS.
DISCLAIMER: This set of instructions is given according to IEC 704-1.
AAEON disclaims all responsibility for the accuracy of any statements contained
herein.

AAEON Operator Panel
AOP-8060
AOP-8060 Series User Manual 8
Contents
Copyright Notice ....................................................................2
Acknowledgments ..................................................................3
Packing List ............................................................................4
Safety & Warranty..................................................................6
General Information........................................................................9
Introduction...........................................................................10
Specification.........................................................................11
Dimension.............................................................................16
Hardware Installation....................................................................17
Panel Mount Installation.......................................................18
Digital I/O Connector (CN14)..............................................20
COM1 Connector (CN9)......................................................21
COM 2 Connector (CN10) ...................................................21
Win CE Installation.......................................................................22
Win CE Installation Steps.....................................................23

AAEON Operator Panel
AOP-8060
AOP-8060 Series User Manual 9
General
Information
Chapter
1

AAEON Operator Panel
AOP-8060
AOP-8060 Series User Manual 10
Introduction
The AOP-8060 operator panel is a SiS Low power processor computer that is
designed to serve as a human machine interface (HMI). It is a PC-based system
with 5.7" color STN LCD display, on-board Ethernet controller, multi-COM port
interfaces and an audio controller. With a built-in CompactFlash socket, the AOP-
8060 is as compact and user friendly as a multi-function computer. In addition, its
"fit anywhere" design makes it very flexible and able to be used in many different
kinds of installations. It can be wall mounted, panel mounted or DIN Rail
mounted.
For system integrators, this simple, complete, compact and highly integrated
system let you easily build a operator panel into your applications. Common
industrial applications include factory automation systems, precision machinery,
and production process control. It is also suitable for many non-industrial
applications, including vending machine, and car park automation. Our operator
panel is a reliable, cost-effective solution to your application's processing
requirements.