A&L Furniture AL284C-UNF User manual

Assembly Instructions for 44” Square Walk-In Table
Tools Needed:
Power drill or screwdriver
#2 Square Drive Bit
Hardware:
4 – 2¾” Wafer Head Bolts
75– 2” Screws
1 - Allen Wrench
Parts List:
Table Top—2 pieces
2”x2”x35” Strips—2 pieces
Table Leg Assemblies—2 pieces
Bench Tops - 4 pieces
1”x5½”x14½” Bench Leg Supports—8 pieces
1”x5½”32” Bench Bottoms—4pieces
Step 1
Lay the table tops upside down & bolt together. Insert the four 2¾” bolts in the predrilled holes in one side
& turn into the threaded inserts with the Allen Wrench. (See photo 1.) Now, attach the 2”x2”x35” strips, use
six 2” screws in each strip. Turn into the predrilled holes and screw down into the table top. (See photo 2.)
photo 1 photo 2
Step 2
Assemble the 4 bench legs. Take two leg supports and attach to a bench bottom. Put two 2” screws in the
predrilled holes in each end of the bench bottom and screw into one end of the leg supports. (See photo 3.)
Step 3
photo 3
Unfold a table leg assembly & place upside down on a table. (See photo 4.) Take a bench top & place up-
side down with the center 2x2 between the 2x4 table leg support beams. Attach with two 2” screws on
each side (See photos 4 and 5)
photo 4 photo 5
*Keep 2x2 even with leg supports*
Predrilled
holes in leg
supports
belong at
this end

Step 4
Now take the bench leg assemblies in Step 2 and place them on the seat. Center with the 2x2 on the
bench top. Attach with two 2” screws on each end. (See photos 6 & 7.)
*Center on 2x2 strips*
photo 7
Step 5
Fold the center leg down and attach to the bench bottom. Put one 2” screw in the predrilled hole in the
center of the bench bottom and screw up into the leg. (See photo 8.) Now, put the 2 base assemblies to-
gether (See photo 9.)
photo 8 photo 9
Step 6
Place the table top on the base and latch down into the 4 corners between the 2x2 braces. (See photo 10.)
Put one 2” screw into each 2x2 and screw into the top of the legs. (See photo 11.)
photo 10 photo 11
photo 6