A&L Furniture Poly User manual

Assembly Instructions for Poly 44” Square Walk-In Table
Tools Needed:
Power Drill or Screwdriver
#2 Square Drive Bit
Parts List:
Table Top—2 pieces
Table Leg Assemblies—2 pieces
Bench Tops - 4 pieces
1”x5½”x14½” Bench Leg Supports—8 pieces
1”x5½”32” Bench Bottoms—4pieces
Step 1
Lay the table tops upside down. Place the 36” aluminum strips along the outside crosspieces on the top &
place the 24” aluminum strips along the center crosspieces centering them lengthwise. Attach with the ¾”
screws, 6 screws in the 36” piece & 4 screws in the 24” piece. (See photo 1.) Now attach the small poly
blocks on the end of the leg slots. Attach with 2 - 1½” screws in each block. (See photo 2.)
photo 1
Step 2
Step 3
Unfold a table leg assembly & place upside down on a table. (See photo 4.) Take a bench top & place
upside down with the center 2x2 between the 2x4 table leg support beams. Attach with two 2½” screws
on each side (See photos 4 and 5)
Assemble the 4 bench legs. Take two leg supports and attach to a bench bottom. Put two 2½” screws
in the predrilled holes in each end of the bench bottom and screw into one end of the leg supports. (See
photo 3.)
photo 4
*Keep 2x2 even with leg supports*
Hardware:
64 - 2½” Screws
4 - 1½” Screws
20 - ¾” Screws
2 - 36” Aluminum Strips
2 - 24” Aluminum Strips
2 - Small Poly Blocks
photo 2
photo 3 photo 5
Predrilled
holes in leg
supports
belong at
this end

Step 4
Now take the bench leg assemblies from Step 2 and place them on the seat. Center with the 2x2 on the
bench top. Attach with two 2½” screws on each end. (See photos 6 & 7.)
*Center on 2x2 strips*
photo 6 Step 5
Fold the center leg down and attach to the bench bottom. Put one 2½” screw in the predrilled hole in the
center of the bench bottom and screw up into the leg. (See photo 8.) Now, put the 2 base assemblies
together & screw together with 4 - 2½” screws. (See photos 9 & 10.)
Step 6
Place the table top on the base and latch down into the 4 corners between the 2x2 braces. (See photo 11.)
Put one 2½” screw into each 2x2 and screw into the top of the legs. (See photo 12.)
photo 7photo 6
photo 8 photo 9 photo 10
photo 11 photo 12