
LD0.MAPGAPC5 Multipurpose analog protection
function (5).............................................................................19
LD0.MAPGAPC6 Multipurpose analog protection
function (6).............................................................................19
LD0.XRGGIO130 Alarm and warning....................................19
LD0.PHPTUV3 Phase undervoltage protection - stage
3.............................................................................................20
LD0.PHPTUV1 Phase undervoltage protection - stage
1.............................................................................................20
LD0.PSPTUV1 Positive-sequence undervoltage
protection - stage 1.................................................................20
LD0.NSPTOV2 Negative-sequence overvoltage
protection - stage 2.................................................................20
LD0.NSPTOV1 Negative-sequence overvoltage
protection - stage 1.................................................................21
LD0.XGGIO120 Physical binary I/O signals (status
only)........................................................................................21
LD0.XGGIO110 Physical binary I/O signals (status
only)........................................................................................21
LD0.XGGIO100 Physical binary I/O signals (status
only)........................................................................................22
LD0.XAGGIO130 Physical binary I/O signals (status
only)........................................................................................22
LD0.MDSOPT1 Generic operation time supervision..............22
LD0.MNSPTOC1 Negative-sequence overcurrent
protection for motors (1).........................................................22
LD0.MNSPTOC2 Negative-sequence overcurrent
protection for motors (2).........................................................23
LD0.JAMPTOC1 Stalled motor protection .............................23
LD0.STTPMSS1 Motor startup supervision (1)......................23
LD0.STTPRMI1 Motor startup supervision (2).......................23
LD0.PREVPTOC1 Phase reversal protection........................23
LD0.MPTTR1 Motor thermal overload protection...................24
LD0.EMSGAPC1 Emergency start ........................................24
LD0.LOFLPTUC1 Loss of load protection..............................24
LD0.ARCSARC1 Fault arc protection - stage 1.....................24
LD0.ARCSARC2 Fault arc protection - stage 2.....................24
LD0.ARCSARC3 Fault arc protection - stage 3.....................25
LD0.EFLPTOC1 Non-directional earth-fault and
sensitive earth-fault protection - low stage 1..........................25
LD0.EFHPTOC1 Non-directional earth-fault and
sensitive earth-fault protection - high stage 1.........................25
LD0.PHIPTOC1 Phase overcurrent protection -
instantaneous stage 1 ...........................................................25
LD0.PHLPTOC1 Phase overcurrent protection - low
stage 1....................................................................................26
Table of contents
2REM615
Point List Manual