ABB ARR600 User manual

Quick Start Guide
ARG600/ARR600 Wireless Gateway
Front and back panel of the dual SIM product variants
Front and back panel of the single SIM product variants
6
4
7
5 8
6
92 3
3
5
1
4
7
1
8
2
10
1I/O connector (only ARR600 models)
2Power supply 12...48 VDC
3Console/serial port
4Power switch
5Console/serial port switch
6DIP switches
7Application serial port (RS2)
8LAN port(s)
9Antenna connector SMA (female)
10 SIM card slot(s)
1LAN port(s)
2SIM card slot(s)
3Console/serial port
4DIP switches
5Application serial port (RS2)
6Antenna connector FME (male)
7Power switch
8Power supply 12...36 VDC

2 Quick Start Guide | ARG600/ARR600
Power-up and SIM card installation
Insert the SIM card. Push the yellow button in the SIM card
slot to eject the SIM card tray. Insert the SIM card to the
tray (contacts facing up) and push it firmly and carefully
back to its holder. Attach the power supply and switch the
device on. Under normal circumstances, the device is able
to automatically connect to the operator‘s cellular network.
In problem situations you can log in to the Arctic Web user
interface by using Web browser and navigating to Network →
Mobile WAN.
If your SIM card requires a PIN code, do not install it
before you have configured the Arctic device PIN code
settings.
Login to the Arctic Web user interface
Connect the Ethernet cable between the Arctic device LAN
port and your computer.
Figure 1. Browser https example
Figure 2. Welcome page in the ARG600 Web user interface
Getting started
Configure your computer to use the same IP address space
as the Arctic device. For example, your computer IP could
be 10.10.10.11 with netmask 255.255.255.0. Check the
connection with the ping command.
Connect to the Arctic device using the Web browser. The
default address of the Arctic device is https://10.10.10.10/.
Remember to use https and not http.
Accept the self-signed certificate in the browser.
Log in to the device. The username is arctic-adm and the
default password is arcticm2m.
It is highly recommended that the default password is
changed before the product is connected to a public
cellular network.

ARG600/ARR600 | Quick Start Guide 3
Getting started
Wireless network settings
Log in to the Arctic Web user interface using your Web
browser.
Navigate to Network → Mobile WAN.
Change the APN type from ”Automatic” to ”Manual”.
Set the Access Point Name (APN) appropriately (usually
INTERNET or operatorname.com). As this setting depends on
your mobile operator, ensure the APN settings directly from
the operator.
Complete customer documentation is available in the product pages that can be accessed through
www.abb.com/mediumvoltage
Figure 3. Mobile WAN settings
Set the other settings such as the PIN code, authentication,
username and password if required by the operator’s
subscription.
Reboot the Arctic device and check the settings and the
cellular network connection status from System →Status.

1MRS758863 A © Copyright 2017 ABB. All rights reserved.
ABB Oy, Distribution Automation
P.O. Box 699
FI-65101 VAASA, Finland
Phone: [phone]
Fax: [phone]
www.abb.com/mediumvoltage
Contact us