ABB InLine II ZHBM-ITS Series User manual

—
Fuse Switch Disconnector
InLine II ZHBM-ITS
—
Fuse Switch Disconnector
InLine II ZHBM-ITS rev. A / 1SEP622739P0001
INSTALLATION INSTRUCTION

—
Tableofcontents

1
FUSE SWITCH DISCONNECTOR, InLine II ZHBM-ITS2.1
—
Useofsymbols
Hazardous voltage
Warnsaboutasituationwhereahazardous
voltagemaycausephysicalinjurytoa
personordamagetoequipment.
General warning
Warnsaboutasituationwheresomething
otherthanelectricalequipmentmaycause
physicalinjurytoapersonordamageto
equipment.
Caution
Provides important information or warns
aboutasituationthatmayhaveadetrimental
effectonequipment.
Information
Provides important information about the
equipment.

—
Receiving,handlingandstorage
2FUSE SWITCH DISCONNECTOR, InLine II ZHBM-ITS2.1
Receiving and handling
Uponreceipt,carefullyinspecttheswitch
fordamagethatmayhaveoccurredduring
transit.Ifdamageisevident,orthereisvisible
indication of rough handling,immediately
fileadamageclaimwiththetransportation
company,andnotifyyourlocalABB salesoffice.
Donotremovetheshippingpackageuntil
the ITS2.1 module is ready to be installed.
Storage
Iftheunitwillnotbeplacedintoservice
immediately,storethedeviceinitsoriginal
packageinaclean,drylocation.Toprevent
condensation,maintainauniformtemperature.
Storetheunitinaheatedbuilding,allowing
adequate air circulation and protection
fromdirtandmoisture.Storingthe unit
outdoors couldcauseharmfulcondensation
inside the package .
HAZARD OF Overturning
Whenmovingwithaforklift,donotremove
theshippingpackageuntilthedevice
isinitsfinallocation.
Failuretofollowthisinstructionwillresult
inpersonalinjuryorequipmentdamage.
Warning
equipment

—
Readthesesafetyinstructions
carefullybeforeusingthisproduct!
3
FUSE SWITCH DISCONNECTOR, InLine II ZHBM-ITS2.1
HAZARDOFELECTRICSHOCK,
EXPLOSION,ORARCFLASH
• Apply appropriate personal protective
equipmentandfollowsafeelectricalwork
practices.
• Thisequipmentmustonlybeinstalled
andservicedbyqualifiedelectrical
personnel.
• Before performing visual inspections,
tests,ormaintenanceontheequipment,
disconnectallsourcesofelectricpower.
Assumethatallcircuitsareliveunless
theyarecompletelydeenergized,tested,
grounded,andtagged.Payparticular
attentiontothedesignofthepower
system.Considerallsourcesofpower,
including the possibility of backfeeding.
• Turnoffswitchbeforeremovingor
making load side connections.
• Alwaysuseaproperlyratedvoltage
sensingdeviceatalllineandloadtoconfirm
switchisoff.
• Turnoffpowersupplyingswitchbefore
doinganyotherworkonorinsideswitch.
Failuretofollowtheseinstructionscould
resultindeathorseriousinjury.
Danger

—
Busbar overview
FUSE SWITCH DISCONNECTOR, InLine II ZHBM-ITS2.1
185
100
185
100
ZHBM00-ITS
ZHBM123-ITS
4

—
FUSE SWITCH DISCONNECTOR, InLine II ZHBM-ITS2.1 5
—
FUSE SWITCH DISCONNECTOR, InLine II ZHBM-ITS2.1
ZHBM123-ITS
ZHBM00-ITS
1
3
2
1 Withdraw the connectors
Disassembling the ITS
A
BB
2 Pull out the ITS

—
FUSE SWITCH DISCONNECTOR, InLine II ZHBM-ITS2.1
—
6FUSE SWITCH DISCONNECTOR, InLine II ZHBM-ITS2.1
A
B
TCP Module

—
FUSE SWITCH DISCONNECTOR, InLine II ZHBM-ITS2.1 7
TCP Module

—
FUSE SWITCH DISCONNECTOR, InLine II ZHBM-ITS2.1
8
CLICK!
TCP Module

—
FUSE SWITCH DISCONNECTOR, InLine II ZHBM-ITS2.1
ZHBM00-ITS
9
Busbar mounting
M8
10Nm

—
FUSE SWITCH DISCONNECTOR, InLine II ZHBM-ITS2.1
ZHBM123-ITS
10
Busbar mounting
M12
25Nm

—
Assembling the ITS
FUSE SWITCH DISCONNECTOR, InLine II ZHBM-ITS2.1
ZHBM00-ITS ZHBM123-ITS
13
2
1 Plug in the connectors
2 Push in the ITS
CLICK!
11

FUSE SWITCH DISCONNECTOR, InLine II ZHBM-ITS2.1
48,5
809,5
655
( )154,5
213
152,5
6
3,5
3,5
5788
100185185
99
809,5
655 ()
154,5
218 3,5
6
788
5
3,5
152,5
100
185
185
100
CZ
ZHBM00-ITS ZHBM123-ITS
12

—
Contactus
ABB Oy
Smart Power
P.O. Box 622
FI-65101 Vaasa
Finland
© Copyright 2020 ABB. All rights reserved.
Specifications subject to change without notice.
InLine II ZHBM-ITS rev. A / 1SEP622739P0001 # 05.20.2020
> Low Voltage Products and Systems
https://new.abb.com/contact-centers