Abestorm Guardian SN90 User manual

Congratulations on purchasing a new Guardian SN90 Dehumidifier.Your new dehumidifier
comes with an extensive warranty plan. To register, simply fill in and return the warranty
card provided in your dehumidifier box.
Be sure to note your dehumidifier serial number as you will need it for registration.
The Guardian Series Dehumidifier must always be connected using a grounded
electricalconnection (as required for all electrical appliances). If non-grounded
wiring isused, allliability reverts to owner and the warranty is voided.
GuardianDehumidifiers should only be maintained and repaired by a qualified technician.
GuardianDehumidifiers are only intended for operation when oriented with the unit sittingon its
feet and level.Operating the unit in any other orientation
could allow electrical components.
Always unplug the dehumidifier before moving.
lf there is a chance that water flooded the dehumidifier, it should be opened and allowedto dry
thoroughly before reconnecting to electrical power and restarting
To ensure proper operation, neither the inlet nor discharge should be positioned againsta wall.
The inlet requires a minimum of 12” clearance and the discharge
requires a minimum of 36”clearance.
The best option for proper diffusion of air throughout the room is to have the dischargeblowing
away from a wall and the inlet pulling air in parallel to a wall.
Do not insert your fingers or any objects into the inlet or discharge.
All work on the dehumidifier should be done with the unit "off " and unplugged.
Do not use water to clean the exterior.To clean unit, unplug from power, then use
a dampcloth to wipe the exterior.
Do not stand on machine or use as a device to hang clothes.

Use this button to turn the dehumidifier on and off.Press once to turn machine on .You will
heartwo beeps and the OPower light will lluminate green Press the power button asecond
time and you will hear one beep as the machine shuts down. Note that thereis a one
minute fan delay on shutdown.
Use the up and down arrow buttons to set the desired humidity setpoint on the dis -
To switch into continuous mode, set the humidity below 36%.At this point the Cont.
light should illuminate green on the display board to indicate you have succesfully
switched to continuous mode.The display screen will show"Co".
When set to continuous, the dehumidifier will run constantly, regardless of the humidity
level.To stop the dehumidifier from running, turn the unit off or switch back to normal
humidistat operation. To swtich back to normal humidistat operation, simply move the
setpoint above 36%.
play screen.
point means that when the indoor humidity is lower than the set point, the machine
will stop automatically.Conversely, when the indoor humidity is higher than the set
level, the unit will operate. NOTE: The humidity levels displayed are approximate
only (+/-5%).
The setpoint can be any number between 36-90%.Creating a set -

Down Button