ADTRAN D4-n x 56 DSU DP User manual

SECTION XXXXXXX-XX
PAGE 1
D4- n x 56/64 DSU DP
n x 56/64 DATA SERVICE UNIT DATAPORT

SECTION XXXXXXX-XX
PAGE 2
D4- n x 56/64 DSU DP
n x 56/64 kB/s
Data Service Unit Dataport
FEATURES BENEFITS
• Plugs into WECO®D4 or equivalent, SLC 96, and • Compatible with a large installed base of channel
the ADTRAN ACT 1 and AD4-24 channel banks banks
• Operates at data rates of n x 56 or n x 64 where • Numerous bandwidth requirements supported by
n = 1 to 24 or 56 kB/s to 1.536 MB/s one card
• Supports 64K Clear Channel operation • Allows more efficient utilization of network bandwidth
• Selectable stuff bit in non-Clear Channel (56 kB/s) • Ensures network required 1s density; provides
mode capability to avoid false yellow alarm occurrences
• Data may be assigned to consecutive or alternating • Supports full and fractional T1 network services
time slots
• EIA 530 and V.35 interfaces supported • Compatible with existing DTE interfaces
• Allows for bridging by disabling received data and • Provides for both point-to-point and multipoint modes
timing outputs while allowing transmit data and
timing inputs to be unterminated
• Test modes include Local Loopback, Remote • Enables quick and accurate problem isolation
Loopback (V.54 compatible), Remote Loopback
with Test Pattern, Self Test
• Provides both internal and external transmit clock • Enhances network synchronization options
selections
DESCRIPTION
TheADTRAN n x56/64DSUDPallowsfor connection
of Data Terminal Equipment (DTE) devices at very high
datarates. The n x56/64DSUDPacceptsdatafromthe
customerovereitheranEIA-530orV.35interface. Itthen
translates the composite bandwidth from the user into
individual 56 or 64 kB/s channels for transport through
either public or private network facilities. The number of
time slots utilized, which determines the amount of
bandwidthavailabletotheuser,isselectedbysettingthe
two rotary switches that program the value of n. An
additionalswitchoptionallowsforselecting56kB/sor64
kB/smode. Thenetworkmustbecapableoftransporting
64 kB/s Clear Channel data before this option may be
utilized.
The combination of these two parameters determines
the operating bandwidth. This allows for data rates from
56K( n =1and56Kmode)to1.536MB/s( n =24and64K
mode). Data from the n x 56/64 DSU DP, in the form of
individual time slots of information, is routed to the
commonequipmentsectionof the channelbank. There,
it is combined with information from other channel unit
devicesto forma composite T1stream. The T1signal is
then available for transport over existing T1 or fractional
T1 service offerings. The inverse of the procedure
described above occurs at the remote channel bank
location and the composite bandwidth is reconstructed
and delivered to the remote user.
®WECO is a registered trademark of AT&T Technologies, Inc.
n x 56/64 OPERATION (CONCEPTUAL)
ADTRAN ACT1 (or D4) CHANNEL BANK
EIA 530
384 kB/s DATA
n x56/64 DSU DP
N=6
64K MODE
n
x56/64
176543224
6 TIME SLOTS
@ 64K=384K
NETWORK
T1
n
x56/64
n
x56/64
n
x56/64
n
x56/64
n
x56/64

SECTION XXXXXXX-XX
PAGE 3
APPLICATIONS
VIDEO TELECONFERENCING AT 384 kB/s
LOCAL AREA TO WIDE AREA NETWORKING AT 512 kB/s
FILE TRANSFER APPLICATION AT 256 kB/s
ACT 1
n
x
56/64
(6 x 64)
384K
T1
NETWORK
BRIDGE/
ROUTER
n
x
56/64
(8 x 64)
D4
512K
NETWORK
T1
n x56/64
(4 X 56)
ACT 1 ACT 1
224K 224K
T1
n x56/64
(4 X 56)

SECTION XXXXXXX-XX
PAGE 4
SPECIFICATIONS
Data Rates: 56K Mode - 56,112, 168, 224, 280, 336, 392, 448, 504, 560,616, 672, 728, 784, 840, 896,
952, 1008, 1064, 1120, 1176, 1232, 1288, 1344 kB/s
64K Mode - 64, 128, 192, 256, 320, 384, 448, 512, 576, 640, 704, 768, 832, 896, 960, 1024,
1088, 1152, 1216, 1280, 1344, 1408, 1472, 1536 kB/s
DTE Interfaces: Conforms to EIA 530 and CCITT V.35 specifications
DS1 Facility Interface: Fully compliant with D4 channel bank equipment
Options: Selection of n (1 to 24)
Stuff Bit Location (Bit 8 or 2)
Mode of Operation (56 or 64 kB/s)
Time Slot Arrangement (Consecutive or Alternating)
Data Polarity (Normal or Inverted)
DTE Interface (V.35 or EIA 530)
Transmit Timing (Internal or External)
Receive Outputs (Enable or Disable)
Transmit Inputs (Terminated or Unterminated)
Backplane DTE Interface (Connected or Disconnected)
Faceplate Indicators: LLB Local Loopback
RLB Remote Loopback
ERR Error
TD Transmit Data Active
RD Receive Data Active
Test Modes: Local Loopback, V.54 Remote Loopback, V.54 Remote Loopback with
Test Pattern (Test Pattern 511), Self Test
Mechanical: Size - 4.4 inches high, 1.4 inches wide,
10 inches deep
Weight - 12 ounces (nominal)
Mountings - D4, ADTRAN ACT 1, ADTRAN AD4-24
channel banks
Environmental Operating Temperature - 0°to 50°C
Storage Temperature - -40°to 85°C
Relative Humidity - Up to 95%, non-condensing
ORDERING INFORMATION
Equipment ADTRAN Part Number
D4- n x 56/64 DSU DP 1100025L1
61100.025L1-8B
April 1992
Printed in USA
Specifications subject to change without notice
4955 Corporate Drive • Huntsville, Alabama 35805 • [phone] • FAX [phone]