Advantech IPC-601-SCA User manual

IPC-601-SCA
1Ue-ServerChassis

Copyright Notice
This document is copyrighted, November 2000, by Advantech Co.,
Ltd. All rights are reserved. Advantech Co., Ltd. reserves the right to
make improvements to the products described in this manual at any
time without notice.
No part of this manual may be reproduced, copied, translated, or
transmitted in any form or by any means without the prior written
permission of Advantech Co., Ltd. Information provided in this
manual is intended to be accurate and reliable. However, Advantech
Co., Ltd. assumes no responsibility for its use, nor for any infringe-
ments of the right of third parties which may result from such use.
Acknowledgments
IPC-601 and PCA-6102P1V are trademarks of Advantech Co., Ltd.
Note: The information in this document is provided for
reference only.Advantech does not assume any
liability arising out of the direct or indirect use of the
informationor productsdescribedherein.This
manual is subject to change without notice.
PartNo.2002060100
1st Edition Printed in Taiwan Nov. 2000

Contents
Chapter 1 Introduction..........................1
1.1 Introduction.....................................................................2
1.2 Specifications..................................................................2
1.3 Dimensions......................................................................4
Chapter 2 System Setup.......................5
2.1 Removing the Cover........................................................6
2.2 Installing CPU and Add-on Cards.................................7
2.3 Replacing the Fan...........................................................8
2.4 Adding Disk Drives.........................................................8
Appendix A Passive Backplane.......13
Appendix B Alarm Board...................15
Appendix C SCA-2 Backplane..........17
Appendix D Exploded Diagram........19
Appendix E Safety Instructions........21
E.1 English............................................................................21
E.2 German - Wichtige Sicherheishinweise.................... 22

Introduction
This chapter gives background informa-
tionon theIPC-601-SCA.
Sections include:
• Introduction
• Specifications
• Dimensions
1
CHAPTER

2IPC-601-SCA User's Manual
1.1 Introduction
The IPC-601-SCA is a 1U high, rack-mount e-Server chassis for high-
density internet services. Engineered for service providers and
enterpirses, the IPC-601-SCA's rack-mount 1U form factor is best for
stacking servers as services grow. The IPC-601-SCA is designed to
accommodate PICMG passive backplane and full-sized CPU card
configurations to provide flexibility with high reliability. With various
CPU cards configuration options, the IPC-601-SCA provides flexibility
and high performance at the same time.
1.2 Specifications
•Construction:Heavy-duty steel
•Disk drive capacity: Three optional hot-swap hard disc drive space
and one slim-type CD-ROM disk drive and one slim-type floppy disk
drive.
•Indicators:LEDs for powerOn/Off,HDD and alarm
•Controls: Momentary power switch and alarm reset switch on front
panel
•Coolingfan: Three 7 CFM cooling fans, 21 CFM in total
•Weight: 8kg (17.6 lbs)
•Dimensions(WxDxH): 482x610x44mm(19"x 24" x 1.7")
•Interiorpaintcolor: Black2U2X; Fabric Texture
Passive backplane (PCA-6102P1V)
•Slots:One PICMG slot for full-sized CPU card, and one PCI slot for
expansion
•PCboard: 4-layer PCB with ground and power planes for reduced
noise and low power-supply impedance
•Dimensions:313x38mm(12.3"x1.5")

Chapter 1 Introduction 3
Power supply
•Outputrating:320wattsmax.
•Inputrating:115/230VAC,50/60Hz,auto-switch
•Outputvoltage:+3.3V@ 20 A,+5V@32A,+12 V @12A,-5V@
0.5A, -12V @0.5 A, +5 Vsb @2 A
•Minimumload:+5V@1.0A
•MTBF:50,000 Hours @70% load
•Safety:UL/CUL/CE
Environmental specifications
•Operatingtemperature:0~45° C (32~113°F)
•Relativehumidity: 10~ 95% @40° C,non-condensing
•Safety:UL /CE approved
•CE compliant

4IPC-601-SCA User's Manual
1.3 Dimensions
Unit: mm
Figure 1-1: IPC-601-SCA dimensions

Chapter 2 System Setup 5
CHAPTER
2
System Setup
The following procedures are provided
to assist you in setting up the IPC-601-
SCA

6 IPC-601-SCA User's Manual
2.1 Removing the Cover
1. Unscrew the screws at the rear side of the upper cover.
2. Slide the upper cover backwards.
3. Lift up the upper cover.
Please refer to the Figure 2-1 below for illustration.
Figure 2-1: Upper cover removing