Advantech PCM-233A Installation and operation manual

PC M - 233 A SA T A t o I DE m odu le f o r SA T A D e v ice
S t a r t up M a nu al
Before you begin installing your card, please make sure
that the following materials have been shipped:
1. 1 PCM-233
2. 1 Startup manual
If any of these items are missing or damaged, contact your
distributor or sales representati ve immediately.
Note: Acrobat Reader is required to vi ew any PDF
file. Acrobat Reader can be d ownloaded at:
www.adobe.com/Prodindex/acrobat/read- step.
html(Acrobat is a trademark of Adobe.)
• Convert SATA hard drive or storage device to IDE
interface
• Suitable for 3.5”/5.25 SATA Device
• PCM-233A dimension good fit with 3.5” SATA device
CN1
CN2
• Chipset: ACARD ARC772N
• PATA Connector: 40-pin IDE Connector
• SATA Connector: SATA 7+15P Connector
• Power Connector: 4-pin Power Connector
• External Power: +5 V, +12 V
Mechanical and Environmental
• Dimensions (L x W): 98 x 23 mm (3.8” x 0.9”)
• Weight: 30 g
• Operating Temperature: 0 ~ 60° C(32~140° F)
• Storage Temperature: -40 ~ 85° C(-40~185° F)
• Operating Humidity: 0%~90% relative humidity,
non-condensing
• Power Supply Voltage: +5 V, +12 V
• Power Requirements: 3.3 V, max 37 mA
(Digital) 1.8 V, max 150 mA
(Analog) 1.8 V, max 102 mA
CN9
CN5
CN8
CN7
CN3
products, please visit our website at:
PCM-233A Startup Manual
Jumpers
Label
Function
CN5
Master/Slave Select
CN7~9
Ultra DMA Speed
For more information on this and other Ad vantech
http://www.advantech.com
http://www.advantech.com/epc
For technical support and service, please visit our
support website at:
http://service.advantech.com.tw/eservice/
This manual is for the PCM-233A series Rev. A1.
Part No.2006233A00 1st Edition,
June 2008
Connectors
Label
Function
CN1
40-pin IDE Connector
CN2
Power Connector
CN3
SATA Connector
Specifications
Connectors & Jumpers
Features
Packing List

2 PCM-233A Startup
Manual
CN5 Master/Slave Select
Setting
Function
(2-3)
Master*
(1-2)
Slave
* Default Setting
CN7, 8, 9 Ultra DMA Speed
CN7 CN8 CN9
* Default Setting
Installation Guide
1. Configure the device setting before install PCM-233A.
2. Attach the SATA connector on PCM-233A to the
SATA connector at the rear of S ATA device.
Plug in
3. Connect the IDE cable from CPU board to the PCM -
233A and connect the p ower cable to the PCM-233A.
* PARALLEL ATA STANDARD ALLOWS CABLE LENGTHS
UP TO 18 INCHES (46 CENTI METERS).
(1-2) (2-3) (2-3)
200 MB/S
(1-2) (2-3) (1-2)
133 MB/S
(1-2) (1-2) (2-3)
150 MB/S*
(1-2) (1-2) (1-2)
Reserved
Setting
Function