AEG MWTK-60 User manual

1. Unscrew the 4 screws holding the 2 pieces of wood in place, and retain
the screws
2. Hold the MWTK-60 in place and position the 2 pieces of wood against the
cabinet sides and against the MWTK. Remove the MWTK
3. Screw the 2 pieces of wood onto the base of the cabinet. The wooden
strips should touch the inside of the front of the
MWTK-60, and be aligned against the side gables.
(wooden stripes 18”= 46cm apart)
4. Being careful not to scratch the microwave door, lift the microwave onto
the wooden strips, and move it back about 2 inches.
5. Place the MWTK-60 into position. Use the 4 screws and screw them
through the flanges into the side gables.
6. Pull the microwave forward, and align the front of the microwave with
the front of the MWTK-60
7. To stop the microwave from sliding backwards whilst opening it, it might
be necessary to attach a piece of wood behind the feet of the microwave,
on the wooden supports
8. Air must be able to flow from the microwave upwards and into the room,
or roof space. Failure to comply will void the manufacturer’s warranty on
the micro wave oven.

•For use with Panasonic microwave NNSD797 or equivalent
•Wooden support provided with MWTK60 kit
•Please keep and reuse wood screws provided with the kit
80MM
Support Blocks
Shelf

AEG products are designed and built to the highest standards.
Each appliance is covered by a comprehensive 2 year parts and labour warranty.
Refer to product warranty policy for complete terms and conditions.
For Service & Parts
EURO-PARTS
AEG appliances are imported and distributed in North America by Euro-Line Appliances Inc.
For more information visit
www.euro-line-appliances.com / www.elawest.com
871 Cranberry Court
Oakville, ON L6L 6J7
Canada
Toll Free: 1.800.421.6332
Showroom: 905.829.3980
[e-mail]
2912 West 4th Ave
Vancouver, BC V6K 1R2
Canada
Toll Free: 1.855.ELA WEST (352.9378)
Showroom: 604.235.3980
[email protected]
39822 Belgrave Rd,
Belgrave, Ontario, Canada,
N0G 1E0
1.800.678.8352