BATTERY INSTALLATION AND REPLACEMENT
OPENING THE SAFE
You must first install the battery which is located in the front protective styrofoam.
To replace the battery, remove the cover by pressing
the tab and turning as shown in the illustration
(counter clockwise).
Install new battery and align cover and install cover
(clockwise).
Batteries included: E-lock (1x9Volt)
Enter Factory Pass Code : 1 - 5 - 9 - #and turn the handle clockwise.
SETTING THE PASSCODE & PASSCODE RESET
After opening the safe, locate the small red button on the inside of the door,
near the hinge. Remove the cap and press the red button until you hear two
beeps. You will see a yellow light on the front faceplate. Enter your new
passcode (minimum of 3, to a maximum of 8 digits) while the yellow light is
illuminated, then press #. The yellow light flashes twice with two beeps, that
means your passcode is succesfully set.
Before closing door, make sure your new passcode is functional.
Enter your new passcode and press # and you will see a green light on
your front faceplate.
If after entering your correct passcode and pressing #, you see a red-light on
your front faceplate, this indicates your battery is low and needs to be replaced.
Please follow instructions for battery installation and replacement.
Low Battery Warning Indicator
Back up key
Remove the cover by pressing the tab and turning the
cover under battery installation. Insert the key in the key
hole and turn key ¼ turn (until stopped) to unlock the
safe. Rotate the handle and open the door.
You can mute/unmute the keypad by entering the button .
Safes with the Alarm-U system
Press “0” for three seconds to active the Alarm-U system. If the safe is tampered
with, the alarm will sound for 30 seconds. To stop the alarm from sounding,
enter the correct passcode.
After tampered alarm, please enter “0” to active the Alarm-U system again.
If 3 incorrect passcode entries are made in succession, the alarm will sound
and the safe will be in automatic lockout for 30 seconds.
If 3 more failed attempts are entered, the keypad will be in lockout for 5
minutes, the after any lockout time end. You can use your back up key at
any time to open the safe.
TM
TM
TM
Turning the keypad sound off/on with Mute-U system
TM
