Agilent Technologies 4294A User manual

Safety Summary
When you notice any of the unusual conditions listed below, immediately
terminate operation and disconnect the power cable.
Contact your local Agilent Technologies sales representative or
authorized service company for repair of the instrument. If you continue
to operate without repairing the instrument, there is a potential fire or
shock hazard for the operator.
nInstrument operates abnormally.
nInstrument emits abnormal noise, smell, smoke or a spark-like light
during the operation.
nInstrument generates high temperature or electrical shock during
operation.
nPower cable, plug, or receptacle on instrument is damaged.
nForeign substance or liquid has fallen into the instrument.

Caution
Do not exceed the operating input power, voltage, and current
level and signal type appropriate for the instrument being used, refer to
your instrument's Function Reference.
Electrostatic discharge(ESD) can damage the highly sensitive
microcircuits in your instrument. ESD damage is most likely to occur as
the test fixtures are being connected or disconnected. Protect them from
ESD damage by wearing a grounding strap that provides a high
resistance path to ground. Alternatively, ground yourself to discharge any
static charge built-up by touching the outer shell of any grounded
instrument chassis before touching the test port connectors..
4294A

Agilent 4294A Precision Impedance Analyzer
Operation Manual
Seventh Edition
FIRMWARE REVISIONS
This manual applies directly to instruments that have the firmware revision 1.1x.
For additional information about firmware revisions, see Appendix A.
Part No. 04294-90060
February 2003
Printed in: Japan

2
Notices
The information contained in this document is subject to change without notice.
This document contains proprietary information that is protected by copyright. All
rights are reserved. No part of this document may be photocopied, reproduced, or
translated into another language without the prior written consent of Agilent
Technologies.
Agilent Technologies Japan, Ltd.
Kobe Instrument Division
1-3-2, Murotani, Nishi-Ku, Kobe-shi, Hyogo, 651-2241 Japan
© Copyright 1999, 2001, 2002, 2003 Agilent Technologies Japan, Ltd.
Manual Printing History
The manual’s printing date and part number indicate its current edition. The
printing date changes when a new edition is printed. (Minor corrections and
updates incorporated in reprints do not necessitate a new printing date.) The
manual part number changes when extensive technical changes are incorporated.
April 1999 First Edition
May 1999 Second Edition
December 1999 Third Edition
January 2001 Fourth Edition
March 2002 Fifth Edition
November 2002 Sixth Edition
February 2003 Seventh Edition