Ahrend Silence Call 2.0 User manual

Manual Silence Call 2.0

Tools
8 mm
PH2
SW 3 / 4 / 5 / 6 / 8
2 People

Pre assembly wall
8 x M 10 x 20 Countersunk
Page 01
SW6

Assembly door hinges
2 x M6 x 16 (do not use M6 x 14)
Page 02
SW4
max 8 Nm
max 8 Nm

Assembly door handle
There is also a manual in the box
Page 03
SW4
max 8 Nm

Position of the powersocket
If you do not use a socket positioned under the Call, continue on page 05.
Place floor over socket!Powercable
Power from floor
Finish this page
Power from wall
Page 05
Power from ceiling
Page 05
Page 04

Adjust the floor
Make sure wheels are of the floorMake floor level
Page 05
8

Place EKM wall on the floor
4 x M8 x 25 FlatheadOpening floor!
Page 06
SW5

Place opposing wall on the floor
4 x M 8 x 25 Flathead
Page 07

Place the window profile between the side panels
Make sure you position the glass profile at the rear!
Take notice of the position of the electric panel!
Use profile 33 x 22 mm
Page 08
Make sure to place it in the corner
43 33

Install window profile to both floor and walls
2 x Tighten bolts (ONLY 2!)8 x Loosen bolts slightly
use M5 x 12 for
fastening sides
LONG
#03
#04
#01 #05
Page 09
use M5 x 12 for
fastening boom
#02
#03
SW3
use plasc llers to
open up seal, and
prevent damage

Place the door profile between the side panels
Take notice of the position of the electric panel!
Page 10

Install door profile to both floor and walls
6 x Tighten bolts
Use M5 x 40 for
fastening sides
LONG
#01
#03
#04
Page 11
Use M5 x 12 for
fastening boom
#02
#01
SW3
Use plasc llers to
open up seal, and
prevent damage

Place window in profile
Use Fillers to LOCK Glass, ALL SIDES!
Place boom llers rst!
Page 12
Posion of Fillers

Click closing profiles on window profile
4 x CLICK profiles
Page 13
#01
#02

Install rubber profile to seal & lock the window
Use cleaner on glass for easy fit
A2
Page 14
GLASS
CLEANER

Position the door in the door profile
Page 15

6 x Tighten bolts
Install the hinges in the door profile
2 mm Spacing (top & bo�om)
Place hinge in opening doorframe
Page 16
SW3

Adjust the door
6 x Tighten bolts6 x Loosen bolts
4 mm
4 mm
6 mm
Use Fillers
Pag e 17
#02
#03#01

Install the table brackets
Horizontal!6 x Wood screw 5 x 50
Pag e 18
PH2