aidapt VB540B Programming manual

EN
Shower Chair
VB540B
Usage and Maintenance Instructions

Usage and Maintenance Instructions Ver. 1 04/2013 (2613)
2
INTRODUCTION
Thank you for deciding to purchase the Shower Chair from Aidapt. When used correctly it is
designed to give many years of reliable trouble-free service.
NB. This equipment must be installed by a competent person.
1 0 kg (18 3/4 stone) weight limit.
Do not exceed the wei ht limit stated – doin so could put the user at risk.
BEFORE USE
•Carefully remove all packaging. Avoid using any knives or other sharp instruments
as this may damage the product.
•Check the product for any visible damage. If you see any damage or suspect a fault,
do not use your product, but contact your supplier immediately for support.
PARTS LIST
NO.
DESCRIPTION
SPECIFICATION
QTY
7 Seat Board 1
6 Spring Pin Ø 8 4
5 Vaulted Washer Ø 6 5
4 Screw M6x35 5
3 Telescopic Tube 4
Lower Tube 1
1 Upper Tube 1
ASSEMBLY PROCEDURE
1. Join the Upper an d Lower Tubes as shown in Fig. 1.
. Lay the seat upside down and put the joined Upper and Lower Tubes into the slot
of the seat ensuring that marks correspond as per Fig. , then tighten all screws.
3. Turn the assembled Shower Stool the right way up on a flat surface. Equally adjust
each of the legs to the same height/number setting as per Fig. 3. Remember to
check the spring pins after use.
NB. We do not recommend the use of a battery operated screw driver when assemblin
this product.

Usage and Maintenance Instructions Ver. 1 04/2013 (2613)
3
ASSEMBLY DIAGRAM
Fi . 1 Fi . 2 Fi . 3
HEIGHT ADJUSTMENT
1. Depress the securing pin and twist the extension leg to the side to allow you to
slide the extension leg up or down to the desired height.
. Rotate the leg back to allow the securing pin to pop out of the hole and fix the
height at the correct setting.
3. Repeat steps 1 and above for each leg, ensuring that all four legs are set to the
same height setting.
CLEANING
All of the product components are manufactured from quality materials. However, it is very
important that you only clean your shower chairs and stools using a non-abrasive cleaner or
mild detergent with a soft cloth, avoid using lime scale remover. Abrasive cleaners e.g. AJAX
and or abrasive cleaning pads will seriously damage your product beyond repair.
Do not exceed 50
o
C when cleaning the seat as this will permanently damage the plastic.
N.B. Re ular daily cleanin will reduce the buildup of limescale on your product.

Usage and Maintenance Instructions Ver. 1 04/2013 (2613)
4
REISSUE
If you reissue or are about to reissue this product, please thoroughly check all components
for their safety. This includes:
•Bent or damaged tubes or cracks at the tube joints.
•Elongated adjustment holes.
•Loose or worn fasteners
•Smooth, worn or split ferrules (rubber tips).
Replace all worn, missin or dama ed parts where necessary. If in any doubt, please do
not issue or use, but immediately contact your supplier for service support.
CARE & MAINTENANCE
Please make a check of the product at regular intervals or if you have any concerns.
IMPORTANT INFORMATION
The information given in this instruction booklet must not be taken as forming part of or
establishing any contractual or other commitment by Aidapt Bathrooms Limited, Aidapt
(Wales) Ltd or its agents or its subsidiaries and no warranty or representation concerning the
information is given.
Please exercise common sense and do not take any unnecessary risks when using this
product; as the user you must accept liability for safety when using the product.
Please do not hesitate to contact the person who issued this product to you or the
manufacturer (detailed below) if you have any queries concerning the assembly/use of your
product.
Aidapt Bathrooms Ltd, Lancots Lane, Sutton Oak, St Helens, WA9 3EX
Telephone: [phone] • Fax: [phone] • Web: www.aidapt.co.uk
Email: [email protected] • [email protected] • [email protected]