
N.B. This equipment must be installed by a competent person.
Instructions for:
VB499/VB500 Milton Shower Chair 190 kg (30 st.) weight limit
VB501 L ton Shower Chair 190 kg (30 st.) weight limit
VB648/VB506/VB650 Hythe Shower Chair 190 kg (30 st.) weight limit
VB507 Charing Shower Chair 190 kg (30 st.) weight limit
VB510 Darenth Shower Chair 190 kg (30 st.) weight limit
VB511 Ro nd Adj stable Shower Stool 115 kg (18 st) weight limit
VB509 Rochester Shower Stool 190 kg (30 st.) weight limit
VB508 Dartford Shower Stool 190 kg (30 st.) weight limit
VB635 Strood Shower Stool 159 kg (25 st.) weight limit
VB636 Pemb ry Corner Shower Chair 159 kg (25 st.) weight limit
UUDo notUU exceed the weight limit stated – doing so could put the user at UUris UU.
Fixing and Maintenance Instructions
Shower Chairs
09/11/10
996
1. All Shower Chairs/ Stools
Please examine yo r shower chair for any visible damage before sing. If yo see any damage or s spect a
fa lt, please contact yo r s pplier.
In this case, please do not use your product as it may compromise your safety.
U
2. Cleaning
All of the prod ct components are man fact red from q ality materials. However, it is very important that
yo only clean yo r shower chairs and stools sing a non-abrasive cleaner or mild detergent with a soft
cloth avoid sing lime scale remover. Abrasive cleaners e.g. AJAX and or abrasive cleaning pads will
serio sly damage yo r prod ct beyond repair.
Certain prod cts have clip on/clip off backs and/or seats, yo can easily remove these if req ired, clean with
a mild detergent and soft cloth in a warm water sol tion. Do not exceed 50
o
C when cleaning the seat cover
and/or back as this will permanently damage the plastic.
N.B. Regular daily cleaning will reduce the build up of limescale on your product.
Under No Circ mstances se any abrasive cleaners or materials on any of the components. Also check that
the cleaner yo intend to se is s itable for ABS, Vinyl, Polymer Plastics and Thermo plastic r bbers and
Poly rethane R bber.
3. Adjustments to Extension Legs
Remove the ‘E’ clip from the extension leg and extend all fo r legs evenly to the desired height ens ring
yo do not exceed the last p nched hole of the extension leg. (see fig. 1)
Once yo have achieved the desired height; reinstall the ‘E’ clip, ens ring that it has passed thro gh the
extension leg and is fitting neatly and sn g aro nd the o tside leg. (see fig. 2).
Never install the extension legs nevenly or slanting, this will compromise the safety of the ser.