Aircatglobal VirtualFly VF-G1000 User manual

VF-G1000 Turnkey | User's manual
B
1x
1x
A
. PACKAGE LIST
A) VF-G1000 Turnkey (pack 1)
B) Gaming Joystick (pack 2)
VF-G Turnkey
(Garmin G Trainer model)
USER'S MANUAL
Rev. 1.1 - September 2019
. HOW TO START THE VF-G Turnkey
2.1. CONNECT THE JOYSTICK
Connect the Joystick (sent in another package) via one of the back USB connector.
2.2. PLUG
Plug the VF-G1000 Turnkey in a wall power socket.
2.3. START PC
Press the start button of the miniPC and wait for it to boot completely. (1,5 minutes approximately).
230 VAC




VF-G1000 Turnkey | User's manual
2.4. ACTIVATE PANELS
Push the POWER ("Vol SQ") button in PFD and MFD panels, to activate the screens of the G1000.
2.5. START THE FLIGHT PROCEDURES
The joystick is used to control the flight of the virtual plane. (You will see the flight parameters on PDF and MFD).
The axes of the Joystick are already configured: pitch, roll, rudder and throttle.
3.1. TEAMVIEWER ACTIVATION/DEACTIVATION (Only in case you require technical support through remote session)
To activate/deactivate TeamViewer, you must press at the same time NAV & COM buttons.
3.2. SYSTEM STATUS DIALOG ACTIVATION/DEACTIVATION
To activate/deactivate Sistem Status Dialog, you must press at the same time ALT & FMS buttons.
3.3. SOUND SYSTEM ALERTS ACTIVATION
Sound system alerts are disabled by default. To enable sound system alerts, you have to activate the displays with the POWER ("Vol SQ") button, then
disactivate, with the same button, and activate them again.
Second time you activate the displays, sound system alerts are enabled.
. OTHER CONFIGURATION BUTTONS
NAV + COM
ALT + FMS ALT + FMS
NAV + COM
MFD
MFD
PFD
PFD
POWER Vol SQ
POWER Vol SQ
POWER Vol SQ
POWER Vol SQ