AirLive WH-9100MESH User manual

8
13
9
21
17
29
25
Quick Setup Guide
1
Advanced Dual-Band MESH AP/Bridge
WH-9100MESH
English ●●●
Deutsch ●●●
Polski ●●●
Česky ●●●
Русский ●●●
Português ●●●
Españoll●●●
日本語 ●●●

1
1
Dual-Band MESH AP/Bridge
W
1. Introduction
1.1 Preface
English
1.3.1 Hardware Introduction
1.3 System Overview
Warning: Using a power supply with different voltage rating will damage
this product.
1. Access Point
2. 2 attachable 5dBi omni-directional antennas
3. 1 Power injector with power cord
4. 30 m CAT 5 cable with waterproof RJ45 connector
5. 1 Ground cable
6. 1 Mounting kit set
7. 1.5m low loss antenna cable
8. Documentation as PDF files on CD-ROM
1.2 Package Contents
The WH-9100MESH product is ruggedized and wall-mountable IEEE
802.11 Wireless Access Point (AP) and Bridge device. The AP and Bridge
mode can work simultaneousl
y
b
y
dual radio interfaces.
1
2
7
3
4
5
6
1. AP Antenna (TX+RX)
2. AP Antenna (RX)
3. Bridge Antenna
4. Reset Button
5. Console Port
6. WAN / LAN Port
7. Ground Pin
English
H
-
9100MES
H

2
2
Dual-Band MESH AP/Bridge
W
1.3.2 LED indicator
English
1.3.3 Hardware Installation
To Power Injector
(Cat5 Cable)
To PC
(Initial Configuration and Lan
function when set up as Gateway
mode)
English
H
-
9100MES
H

3
3
Dual-Band MESH AP/Bridge
W
To Wired LAN
To WAN Port
(Cat5 Cable)
P
ower
I
n
j
ec
t
or
English
2. Enter Configuration Screen
The default IP of LAN port is https://192.168.15.1 (AP mode) and
https://192.168.16.1 (Gateway mode).
For the first time, you have to put the URL (https://192.168.15.1) for login
and then you can set up 9100MESH as gateway mode.
(Note: Please type “https” not “http”.)
English
H
-
9100MES
H

4
4
Dual-Band MESH AP/Bridge
W
You will be asked for your user
name and password.
Enter the default username
“airlive”, and the default
password “airlive” to give full
access for setup configuration.
(This password is case-sensitive)
English
3. System Configuration
3.1 Operation Mode
You can set up 9100MESH as standard Access Point function, or
Gateway.
At AP mode, it virtually connects wireless users to the host wired network.
The IP addresses for wireless devices are typically assigned by the wired
network’s DHCP server. All wireless devices connected to the AP are
configured on the same sub network as the wired network interface and
can be accessed by devices on the wired network.
Gateway mode provides private IP address for the wireless clients and is
different sub-network from wired network interface. Gateway mode takes
advantage of some built-in “router” function, such as the Network Address
Translation (NAT) and Firewall. The NAT provides private IP address
English
H
-
9100MES
H

5
5
Dual-Band MESH AP/Bridge
W
3.2 WAN Configuration
English
You can choose “Using DHCP to get an IP address”. By this way, the
9000MESH will get an IP address from DHCP server.
If your network environment is without DHCP function, then you need to
use static IP for WAN port. Then, the 9100MESH network administrator
may need the following information:
zIP address -a list of IP addresses available on the organization's LAN
there are available to be used for assignment to the AP(s)
zSubnet mask
zDNS IP address
English
H
-
9100MES
H

6
6
Dual-Band MESH AP/Bridge
W
3.3 LAN Configuration
English
Click the entry on the left hand navigation panel for System
Configuration – LAN. This directs you to the System Configuration –
LAN page.
This set up the default numbers for the four octets for a possible
private LAN function for the AP. It also allows changing the default
numbers for the LAN Subnet Mask. The Local LAN port provides
local access for configuration. It is not advisable to change the
private LAN address while doing the initial setup as you are
connected to that LAN. If you do change DHCP IP address as new
one, you need use the IP you key in to enter configure screen again
after clicking Apply button.
4. Wireless Access Point Configuration
Click the entry on the left hand navigation panel for Wireless
Access Point – General. This directs you to the Wireless Access
Point – General page.
English
H
-
9100MES
H

7
7
Dual-Band MESH AP/Bridge
W
The AirLive WH-9100MESH product is ruggedized and wall-mountable
IEEE 802.11 Wireless Access Point (AP) and Bridge device.
The major feature of 9100MESH is Wireless Mesh Network function.
The 9100MESH also provides Gateway mode, Layer 2 (Client)
isolation, Multiple SSID/VLAN and Gateway Mode features. When
9100MESH set up at Gateway mode, it provides firewall function to
enhance network security.
For more setting and applications please refer to user’s manual.
MAC address
The MAC address list here is AP’s wireless interface
SSID
If you will be using an SSID for a wireless LAN, enter it here and in
the setup of each wireless client.
Wireless Mode
The wireless Mode menu allows you to specify whether you want AP
to operate solely in the 802.11a, 802.11b, and 802.11g or in a
combination of 802.11b/g.
Channel Number
The channel number is a means of assigning frequencies to a series
of access points. If you are using the WH-9100MESH as both an AP
and bridge, the channel number set for the AP and the one for
bridge should be sufficiently different to avoid interference. Before
you setting the channel, you had better to use the optimal channel
function to detect the environment’s radio signal and choose the
best one for using.
English
English
H
-
9100MES
H

Tested To Comply
With FCC Standards.
FOR HOME OR OFFICE USE
2F, No. 8, Lane 130, Min-Chuan Rd, Hsin-Tien City, Taipei, TaiwanOvisLink Corp.
OvisLink Corporation declares that this device is in
compliance with the essential requirements and
other relevant provisions of directive 1999/5/EC
OvisLink Corporation declara que el dispositivo
cumple con los requerimientos básicos y otras
facilidades relevantes de la directriz 1999/5/EC
EN PT
Компания OvisLink Corporation заявляет, что это
устройство отвечает основным требованиям и
прочим родственным условиям, изложенным в
директиве 1999/5/EC.
A OvisLink Corporation declara que este dispositivo
está em conformidade com os requisitos essenciais
e outras solicitações relevantes da Directiva
1999/5/EC.
RU
OvisLink Corporation potvrdzuje, že toto
zariadenie vyhovuje požiadavkám a ďalším
predpisom smernice 1999/5/EC.
SK
ES
OvisLink Corporation erklärt hiermit, dass dieses
Gerät den grundlegenden Vorschriften und
anderen relevanten Bestimmungen der
EG-Richtlinie 1995/5/EC entspricht.
DE
Ovislink Corporation deklaruje, že toto zařízení
vyhovuje základním požadavkům a dalším
závazným ustanovením z nařízení 1999/5/EC
CZ
OvisLink deklaruje zgodność swoich urządzeń z
istotnymi wymaganiami oraz innymi istotnymi
przepisami dyrektywy 1999/5/E/C
PL
この装置が指導的な1999/5/EC の必要な条件そし
て他の関連した準備に従ってあるとOvisLink
Corporation は宣言する
JP