Akuvox A092 Series User manual

A092
Quick Guide
A092 x1
Before you begin using the device, please check the version you got and ensure that the following items are included in the
shipped box:
Unpacking
2x6-PIN terminal block x 1
Wall-mounting template x1
Silicon pad (for power supply) X1
Cable gland x1
Wire fastener x3
M3x5 crosshead screw x3
Silicone pad (for wire) x2
ST4x20 crosshead screw x3
Wire x9
Plastic wall anchor x3
Cable tie x5
2x9-PIN terminal block x 2

A092
Product Overview
SNMPS
Aircircuit-Breaker
Independent Relay
Temper Proof Sensor
Lock
Backup Battery Bracket
Status Indicator
Main Board

A092
Installation
Stick the wall-mounting template on the
wall where the device needs to be
installed. According to the screw hole
position on the template, use an electric
drill to drill the hole with a diameter of
6mm and a depth of 25mm.
Insert plastic wall
anchors into the holes.
Knock a lead hole with the
appropriate tool according to
the desired wiring position.
Fix A092 with three ST4x20
crosshead screws on the wall.
Place silicone pad for lead
hole.
Please place cable gland or
silicone pad as the figure shown
according to your need.

A092
The installation is done,
and please lock the cover.
Then remove the
Place the battery as shown in
the figure, and use the fixing
plate and M3X5 crohsshead
screw to fix it.
Connect the provided wire as
shown in the figure, then use
M3X5 crosshead screw and
wire fastener to fix the wire on
the A092.

A092
Device Wiring

A092
Operation
A092 controller can realize the independent control of two doors; Each door can be connected with an electric lock, 2 card readers (inside and outside) 2
key input.
Unlock Door
1. After swiping the card on the card reader, A092 will unlock the electronic lock;
2. Press the door button, A092 will unlock the electric lock.
Fire Alarm
When the fire alarm is triggered, A092 will unlock the electronic lock of all doors.
Configuration
1. While A092 starts up normally, click Search key in the IP Scanner tool to search the IP address. (Please consult Akuvox Technical Team for IP Scanner
tool).
2. Access the Web UI: Type the IP address into browser to configure the device.

A092
Notice Information
Information contained in this document is believed to be accurate and reliable at the time of printing. This document is subject to change without
notice, any update to this document can be viewed on Akuvox’ s website: http://www.akuvox.com © Copyright 2022 Akuvox Ltd. All rights reserved.