Akuvox A092 Series User manual

A092
Quick Guide
Mainframe Accessories :
M4X30 screw x 2
ST4X20 screw x 6
Screw fixing seat x 6
A092x1
Installation Stickerx1
Silicon Pad for Power Supply
Glen head x1
Before you begin using the device, please check the version you got and ensure that the following items are included in the
shipped box:
Unpacking
Wire Fastenerx3
M3x5 screwx10
Silicone Pad
for Wire Protection x1
ST4x20 screwx3
Wire harness
Plastic Wall Anchorx3
Nylon cable tie

A092
Product Overview
SNMPS(A092 Only)
Aircircuit-Breaker (A092 Only)
Independent Relay
Temper Proof Sensor
Lock
Backup Battery Bracket
Status Indicator
Main Board

A092
Installation
Paste the wall installation sticker on the
wall where the equipment needs to be
installed. According to the screw hole
position on the sticker, use the electric
drill to drill the hole with a diameter of
6 and a depth of 25
Install expansion pipe
Knock the lead hole
with the appropriate
tool according to the
desired wiring position
Fix A092 with 3 ST4*20
screws
.
Install silicone pad for
lead hole
Please choose to install
Glen head or power cord
protection silicone pad
according to your needs

A092
Frontal vector drawing
for wiring
About the installation of the
battery: place the battery as
shown in the drawing, and use
the fixing plate and M3X5
screw to fix.
Connect the power cord as
shown in the diagram, then it
is recommended to use M3X5
screw and wire fastening
buckle to fix the power cord
to the A092 host machine

A092
Device Wiring

A092
Operation
A092 controller can realize the independent control of two doors; Each door can be connected with an electric lock, 2 card readers (inside and outside) 2
key input and a fire input;
Open the Door
1. After swiping the card on the card reader, A092 will unlock the electronic lock;
2. Press the door button, A092 will unlock the electric lock;
Fire Alarm
When the fire alarm is triggered, A092 will unlock the electronic lock of all doors;
Configuration
1. While A092 starts up normally, click Search key in the IP Scanner tool to search the IP address.(Please consult Akuvox Technical Team for IP Scanner
tool).
2. Access the Web UI: Input the IP address into browser to configure the phone.

A092
Notice Information
Information contained in this document is believed to be accurate and reliable at the time of printing. This document is subject to change without
notice, any update to this document can be viewed on Akuvox’ s website: http://www.akuvox.com © Copyright 2021 Akuvox Ltd. All rights reserved.