Akuvox R29X User manual

1. On-wall installaon
R29X
Rain Cover Installaon Guide
Combine the wall-mounting box with the rain
cover and mark the six mounting hole positions
on the wall. Drill the holes and insert the six
plastic wall anchors into the holes according to
regular device installation requirement. Then
tighten the combined rain cover and the box
securely on the wall using the six tapping
screws (ST4x20).
Install the device on the wall-mounting box ,
press down the device and make sure that the
two hang holes on its top are fully hanged on
to the two square hooks on the top of the box,
then tighten the two countersunk machine
screws (M3x6) underneath the device using
the Allen wrench attached with the device.
If the device cannot be easily hanged on to the
square hooks, loosen the six cross screws
(ST4x20) slightly, move up the rain cover a
little bit to increase the clearance between the
rain cover top and the box top. Then retighten
the six screws before installing the device.
Installation completed.

AKUVOX (XIAMEN) NETWORKS CO., LTD.
ADD: 10/F, NO.56 GUANRI ROAD, SOFTWARE PARK II, XIAMEN 361009, CHINA
www.akuvox.com
Notice Information
Information contained in this document is believed to be accurate and reliable at the time of printing. This document is
subject to change without notice, any update to this document can be viewed on Akuvox’ s website: http://www.akuvox.com
© Copyright 2020 Akuvox Ltd. All rights reserved.
R29X
Rain Cover Installaon Guide
2. In-wall installaon
Install the embedded box on the wall according to
its installation manual. Combine the flush-mounting
bracket with the rain cover before tighteninig them
securely on the wall using the 6 screws(M4x10)
attached with the device.
Install the device on the flush-mounting bracket,
press down the device and make sure that the two
hang holes on its top are fully hanged on to the two
square hooks on the top of the box, then tighten
the two countersunk machine screws(M3x6)
underneath the device using the Allen wrench
attached with the device.
If the device cannot be easily hanged on to the
square hooks, loosen the six socket head cap
machine screws (M4x10) slightly, move up the rain
cover a little bit to increase the clearance between
the rain cover top and the bracket top. Then
retighten the six screws before installing the
device.
Installation completed.