Allegion Von Duprin 5547WDC-F User manual

*941901-00*
941901-00
Adjustable Vertical Rod Assembly
5547WDC-F
Installation Instructions
© Allegion 2014
Printed in U.S.A.
941901-00 Rev. 01/14-b
Customer Service
1-877-671-7011 www.allegion.com/us
6’ 10" Door 7’ 0" Door 7’ 2" Door 8’ 0" Door hole on end
Hex Rod
Rod Connector Pin
Top Rod Tube
Top Rod Assembly Instruction
Note: Maximum approved door height for 5547WDC-F devices is 9’ 3".
1. Assemble the top rod tube over the hex rod and align the hole in the tube with the hole tha
t
corresponds with predrilled height (6’ 8", 6’ 10", 7’ 0", 7’ 2", 8’ 0") See Figure 1.
2. Align hole and install rod connector pin.
Figure 1
Miscellaneous Door Heights up to 8’ 0"
1. Measure door opening (sill to rabbet)
2. Subtract measured height from 8
’ 0", use space
provided. →
3. Measure the difference from
the 8’ 0" hole
on the rod and scribe a line on the hex rod.
4. Assemble the top rod tube over the hex rod and align
the hole in the tube with the scribed line.
5. Mark location of the hole in the tube on the hex rod.
Drill a 3/16" hole thru the hex rod. See Figure 2.
6. Align the holes and install the rod connector pin.
Constant Dimension 8’ 0"
Measured Height =
Difference
8’ 0" Hole
7’ 2" Hole Drill 3/16" Hole
Difference
Figure 2

Figure 3
Miscellaneous Door Heights up to 10’ 0"
1. Measure door opening (sill to rabbet)
2. Subtract measured height from 10’ 0", use space
provided. →
3. Measure the difference from the 10’ 0" hole
on the rod and scribe a line on the hex rod.
4. Assemble the top rod tube over the hex rod and align
the hole in the tube with the scribed line. (Cut hex rod
if required.)
5. Mark location of the hole in the tube on the hex rod.
Drill a 3/16" hole thru the hex rod. See Figure 3.
6. Align the holes and install the rod connector pin.
Constant Dimension 10’ 0"
Measured Height =
Difference
10’ 0" Hole
Drill 3/16" Hole
Difference