Allen + Roth SP4971 User manual

1
welcoming • sophisticated • inspiring
Serial Number Purchase Date
Questions, problems, missing parts? Before returning to your retailer, call our customer service
department at 1-866-439-9800, 8 a.m. - 8 p.m., EST, Monday - Friday.
ATTACH YOUR RECEIPT HERE
ITEM #0760323
E15607
MODEL #SP4971
Français p. 11
Español p. 21
MEDICINE CABINET
allen + roth®is a registered trademark
of LF, LLC. All Rights Reserved.
Lowes.com/allenandroth
封面 - 第 1 页
第 12 页

3
2
PACKAGE CONTENTS HARDWARE CONTENTS
K
PART DESCRIPTION QUANTITY
A Hinge (preassembled to Cabinet (C)) 2
B Side Mirror 2
C Cabinet 1
D Door (preassembled to Cabinet (C)) 1
E Shelf Glass 3
F Bottom Bracket 1
Short Screw
Qty. 4
Shelf Clip
Qty. 12
Shelf Hole
Plug
Qty. 20 Snap Cap
Qty. 4
Washer
Qty. 4
Bumper
Qty. 2 Long Screw
Qty. 4
Side Mirror Bracket
Qty. 4
Wall Anchor
Qty. 4
Top Clip
Qty. 2
AA BB CC DD EE
FF GG HH II
JJ
B
B
A
D
F
E
E
E
C
第 3 页
第 2 页
Lowes.com/allenandrothLowes.com/allenandroth

54
PREPARATION
SAFETY INFORMATION
WARNING
CAUTION
Please read and understand this entire manual before attempting to assemble or install the
product.
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any part is missing or damaged, do not
attempt to assemble the product.
Estimated Assembly Time: 30 minutes (with recommended two-person installation).
Tools Required for Assembly (not included): Measuring tape, Level, Phillips screwdriver, Stud
finder, Reciprocating saw and Wood shims.
This product can be installed in one of two mounting options: SURFACE MOUNT (continue to
page 5) or RECESS MOUNT (skip to page 8).
• Safety discard all packing material.
• Keep plastic bags and small parts away from children.
• Safety glasses should be worn at all times.
• Do not load this cabinet with more than 50 lbs.
• Do not load each shelf with more than 25 lbs.
• The included plastic wall anchors are intended for use with solid wall applications
only (tile or concrete).
• For recess mount, do not install side mirrors and brackets.
第 4 页 第 5 页
Lowes.com/allenandroth Lowes.com/allenandroth
SURFACE-MOUNT INSTALLATION INSTRUCTIONS
Hardware Used
Hardware Used
1a. For drywall installations: Install bottom bracket (F) a
minimum of 3 inches above your existing faucet/vanity by
inserting two long screws (GG) through bottom bracket (F)
and directly into wall studs. Note: Ensure the marks are
level before proceeding.
1b. For solid wall installations: Using bottom bracket
(F) as a guide, mark screw locations with a pencil (not
included) a minimum of 3 inches above your existing
faucet/vanity. Use a 5/16-in. drill bit (not included) and
drill a pilot hole at marked locations. Insert wall anchors
(HH) into holes, then insert long screws (GG) through
bottom bracket (F) and into wall anchors (HH).
2. Carefully position the cabinet (C) onto the bottom
bracket (F) and hold in place.
1a
1b
2
Long Screw
Long Screw
Wall Anchor
x 2
x 2
x 2
GG
GG
HH
F
F
HH
HH
GG
GG
GG
GG
F
C
Side View
F
C

6 7
SURFACE-MOUNT INSTALLATION INSTRUCTIONS SURFACE-MOUNT INSTALLATION INSTRUCTIONS
5. Remove the paper from the preassembled adhesive
tape on each side mirror bracket (JJ), then carefully
attach side mirrors (B) to each side of cabinet (C).
Proceed to ASSEMBLY INSTRUCTIONS on page 9 to
complete assembly.
5
B
C
JJ
第 6 页 第 7 页
Hardware Used
4. Attach side mirror brackets (JJ) to cabinet (C)
where shown (on both sides) with short screws (AA)
and washers (EE), then snap caps (DD) to cover the
screw heads.
4
Short Screw
Snap Cap
Washer
Side Mirror Bracket
x 4
x 4
x 4
x 4
AA
DD
EE
JJ
Lowes.com/allenandroth
Lowes.com/allenandroth
JJ
EE
AA
DD
C
GG
GG
HH
HH
Hardware Used
Hardware Used
3a. For drywall installations: With the assistance of
another person, install the top clips (II) by inserting the
rounded ends into the rear top slot of cabinet (C).Slide
one top clip (II) to the left and one to the right, then
secure using long screws (GG) through the top clips (II)
and directly into the wall studs.
3b. For solid wall installations: With the assistance of
another person, install the top clips (II) by inserting the
rounded ends into the rear top slot of cabinet (C) Slide
one top clip (II) to the left and one to the right, then mark
locations with a pencil. Temporarily move top clips (II)
out of position, then use a 5/16-in. drill bit (not included)
and drill a pilot hole at marked locations. Move top clips
(II) back into position and insert wall anchors (HH) into
holes, then insert long screws (GG) through top clip (II)
and into wall anchors (HH).
3a
3b
Top Clip
Top Clip
Long Screw
Long Screw
x 2
x 2
x 2
x 2
II
II
GG
GG
II
II
C
C
Wall Anchor x 2
HH

Proceed to ASSEMBLY INSTRUCTIONS on page 9 to
complete assembly.
8 9
ASSEMBLY INSTRUCTIONS
Hardware Used
Hardware Used
Hardware Used
1. Install the glass shelves (E) to the desired positions
with shelf clips (BB), making sure they are level.
2. Use the shelf hole plugs (CC) to seal the empty
holes.
3. Stick the bumpers (FF) at the two corners of the
door (D) opposite the door hinges (A).
1
2
3
Shelf Clip
Shelf Hole Plug
Bumper
x 12
x 20
x 2
BB
CC
FF
Note: These steps are applicable to both surface-mount installations and recess-mount installations.
E
BB
CC
FF
第 8 页 第 9 页
Lowes.com/allenandroth Lowes.com/allenandroth
DD
GG
EE
RECESS-MOUNT INSTALLATION INSTRUCTIONS
Hardware Used
1. Determine desired location for cabinet (C), making
sure to place it where the door can swing freely without
obstruction and where no electrical or plumbling
obstacles would be behind the wall. Note: The height
of the cabinet (C) should be a minimum of 3 in. above
the faucet/vanity.
Using a reciprocating saw (not included), cut away a
rough opening of 14-2/5 in. x 25-1/2 in. x 3-7/8 in. into
the drywall.
2. Mark the opening size of the framing. Once the
drywall is cut, remove any framing in the rough
opening for the item, then frame the cutout opening as
illustrated.
3. Insert cabinet (C) into rough opening and make
sure it is level and plumb; use wood shims (not
included) as required. Then, secure both sides of
cabinet (C) to the studs from the inside using long
screws (GG) and washers (EE). Cover screw heads
with snap caps (DD).
1
2
3
Long Screw x 4
GG
Snap Cap
Washer
x 4
x 4
DD
EE
CAUTION: This installation type is NOT applicable for solid-wall applications.
14-2/5in.
25-1/2in.

10
Printed in China
allen + roth ® is a registered trademark
of LF, LLC. All Rights Reserved.
CARE AND MAINTENANCE
WARRANTY
• Use a household liquid glass cleaner to keep the mirror and glass surfaces clean.
• Do not use abrasive cleaners containing ammonia.
This item is warranted to be free of defects in material and workmanship for one year from date
of installation. This warranty is offered only to the original consumer purchaser and may not be
transferred. This warranty gives you specific legal rights, and you may also have other rights that
vary from state to state. This warranty does not cover defects or damage caused by normal wear
and tear, alterations, environmental conditions, humidity absorption, or mold. This warranty is
considered void if the product fails from accident, misuse, or modified, improper installation or
by affixing accessories not produced by the manufacturer. Some states do not allow the exclusion
or limitation of incidental or consequential damages, so the above limitation or exclusion may
not apply to you. If you would like to make a warranty claim, please contact customer service. All
warranty claims must include the model number of the product, copy of the original receipt and
the nature of the problem. THE MANUFACTURER DISCLAIMS ANY IMPLIED WARRANTY INCLUDING,
WITHOUT LIMITATION, ANY IMPLIED WARRANTY OF MERCHANTABILITY, AND THERE ARE NO
WARRANTIES THAT EXTEND BEYOND THE DESCRIPTIONS ON THE FACE HEREOF. TO THE EXTENT
THAT SUCH DISCLAIMER IS NOT VALID UNDER APPLICABLE LAW, ANY IMPLIED WARRANTY SHALL
BE COEXTENSIVE IN DURATION WITH THIS WARRANTY.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
The doors are not
aligned.
The hinges are
misaligned.
To adjust the doors right or left, loosen/tighten the
screw as in (a). To adjust the doors in or out, loosen/
tighten the screw as in (b). To adjust the doors up or
down, loosen/tighten the screws as in (c).
c
b
a
第 8 页
Lowes.com/allenandroth