
62631 1
© Copyright 2002, Alliance Laundry Systems LLC
All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without
the expressed written consent of the publisher.
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Table of Contents
Section 1 – Safety Information
Locating an Authorized Servicer ............................4
Section 2 – Introduction
Customer Service ....................................................5
Nameplate Location ................................................5
Model Identification ................................................6
How Your Dryer Works ..........................................7
Section 3 – Troubleshooting
1. Motor Does Not Run ........................................9
2. Motor Overload Protector Cycles
Repeatedly ......................................................10
3. Motor Runs But Cylinder Does Not Turn ......10
4. Motor Does Not Stop .....................................10
5. Motor Starts when Door is Closed .................10
6. Heating Element Does Not Heat or Burner Does
Not Ignite .......................................................11
7. Igniter Does Not Glow (Gas Supply Sufficient)
– Gas Models .................................................11
8. Burner Ignites and Goes Out Repeatedly
– Gas Models .................................................11
9. Igniter Glows But Burner Does Not Ignite
– Gas Models .................................................12
10. Heating Element or Burner Shuts Off
Prematurely ....................................................12
11. Heating Element Or Burner Repeatedly Cycles
Off On Limit Thermostat ...............................13
12. Heating Element Or Burner Does
Not Shut Off ...................................................13
13. Clothes Do Not Dry .......................................13
14. Clothes are too Hot When Removed
from Dryer ......................................................14
Section 4 – Grounding
15. Motor Mounting Bracket To Motor (Gas and
Electric Models) .............................................15
16. Motor Mounting Bracket to Exhaust Fan Cover
(Gas and Electric Models with painted exhaust
fan cover – ground wire not used on unpainted
covers) ............................................................15
17. Neutral at Terminal Block to Terminal Block
Bracket and From Terminal Block Bracket to
Control Housing (Electric Models Only) .......16
18. Power Cord to Terminal Block Bracket and from
Terminal Block Bracket to Control Housing.
Wall Receptacle Polarity Check (Gas Models
Only) ..............................................................17
19. Metered and Nonmetered Models – From
Terminal Block Bracket to Accumulator Bracket
or Timer (Depending on model) and From
Cabinet Top to Control Panel ........................18
20. Card Reader Models – From Terminal Block
Bracket to Cabinet Top, From Cabinet Top to
Timer and Cabinet Top to Control Panel .......19
Section 5 – Service Procedures
21. Control Panel, Temperature Switch,
Push-To-Start Switch and Indicator Light .....21
22. Graphics Panel ...............................................21
23. Relays (Card Reader Models) ........................21
24. Timer ..............................................................23
To Test Timer Contacts – Nonmetered
Models.............................................................25
To Test Push-to-Start Switch..........................25
To Test Fabric Temperature Switch ...............26
25. Control Hood – Metered and Non-Metered
Models ............................................................26
26. Control Hood – Card Reader Models ............28
27. Control Hood Rear Cover ..............................28
28. Service Door, Accumulator and Counter
– Metered Models ..........................................28
To Test Accumulator and Timing Motor
– Metered Models ...........................................29
29. Meter Case .....................................................30
30. Timer Case .....................................................31
31. Cabinet Top – Nonmetered Models ...............32
32. Cabinet Top – Metered Models .....................33
33. Cabinet Top – Card Reader Models ..............34
34. Lint Filter .......................................................35
35. Loading Door .................................................36
36. Inner and Outer Door Panels and
Door Handle ...................................................36
37. Door Striker ...................................................36
38. Door Seal .......................................................36
39. Front Panel and Panel Seal ............................37
40. Door Switch ...................................................37
To Test Door Switch.......................................37
41. Striker Catch ..................................................37
42. Door Hinge ....................................................38
43. Hold-Down Clips and Guide Lugs ................38
44. Burner System Operation (Gas Models) ........39
(continued)