Alliance Laundry Systems PD3JGBGS403UG01 Owner's manual

Programming
Dryer
Refer to Page 6 for Model Identification
DRY2733N_SVG
DRY2756N_SVG
Original Instructions
Keep These Instructions for Future Reference.
CAUTION: Read the instructions before using the machine.
(If this machine changes ownership, this manual must accompany machine.)
Part No. D515810ENR3
January 2019

WARNING
Failure to install, maintain, and/or operate this ma-
chine according to the manufacturer's instructions
may result in conditions which can produce bodily
injury and/or property damage.
W030
WARNING
For your safety and to reduce the risk of fire or an
explosion, do not store or use gasoline or other
flammable vapors and liquids in the vicinity of this or
any other appliance.
W022
NOTE: The WARNING and IMPORTANT instructions ap-
pearing in this manual are not meant to cover all possi-
ble conditions and situations that may occur. It must
be understood that common sense, caution, and care-
fulness are factors which cannot be built into these
washers. These factors MUST BE supplied by the per-
son(s) installing, maintaining, or operating the unit.
Always contact the distributor, service agent, or the manufacturer
about any problems or conditions you do not understand.
Read all instructions before using unit.
Hazardous voltage inside. Disconnect power before serv-
icing.
This product uses FreeRTOS V7.2.0 (www.freertos.org).
© Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
3 Part No. D515810ENR3

Table of Contents
Model Identification............................................................................... 6
Preliminary Information.........................................................................7
About the Control........................................................................................... 7
Glossary of Terms...........................................................................................7
Power Failure Recovery.................................................................................. 7
Communications.............................................................................................7
Infra-red Communications........................................................................... 7
Serial Card Reader Communications (Card Models Only)...............................7
Network Communications............................................................................8
Control Identification............................................................................. 9
SELECT CYCLE Pads....................................................................................9
START Pad ................................................................................................... 9
Dryer Operation................................................................................... 11
Power Up Mode............................................................................................11
Ready Mode................................................................................................. 11
Additional Vend Mode...................................................................................11
Start Mode ...................................................................................................11
Entering Coins..............................................................................................11
Entering Cards..............................................................................................11
Special Features ...................................................................................12
Programming Control....................................................................................12
Collecting Audit Information......................................................................... 12
Testing Machine and Control Functions.......................................................... 12
Rapid Advance Feature................................................................................. 12
Start Pulse Operation.....................................................................................12
Opening the Service Door .................................................................... 13
Stacked Washers and Dryers, Stacked Dryers, Front Control Dryers, and Coin
Rear Control Dryers...................................................................................13
Entering the Manual Mode................................................................... 14
How to Enter the Manual Mode......................................................................14
How to Exit Programming Feature................................................................. 15
© Copyright 2019, Alliance Laundry Systems LLC
All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without the expressed
written consent of the publisher.
© Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
4 Part No. D515810ENR3

Manual Reset........................................................................................16
How to Enter Manual Reset........................................................................... 16
Programming Control...........................................................................17
What Can Be Programmed?........................................................................... 17
Programmable Options Available................................................................... 17
Heat Vend Price AtS HChanging Vend Price................................................... 28
Cycle Time CyCt.......................................................................................... 29
Top-Off Data toP-......................................................................................... 29
Vend Price Decimal Point Ats dP....................................................................30
Coin #1 Value dEn 1..................................................................................... 30
Coin #2 Value dEn 2..................................................................................... 30
Testing Machine and Electronic Control Functions............................... 32
How to Enter Testing Feature.........................................................................32
How to Start Tests.........................................................................................32
How to Exit Testing Feature...........................................................................32
Diagnostic Test Descriptions..........................................................................35
Control Software Version Number Test........................................................35
Input/Output Board Software Version Number Test...................................... 35
Service Door Opening Test.........................................................................35
Coin Vault Opening Test............................................................................ 35
Coin Drop #1 Input Test.............................................................................35
Coin Drop #2 Input Test.............................................................................35
Start Pulse Test..........................................................................................35
Factory Test Cycle........................................................................................ 35
To Enter Factory Test Cycle....................................................................... 35
To Exit Factory Test Cycle......................................................................... 36
Error Codes..........................................................................................38
© Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
5 Part No. D515810ENR3