AmazonBasics B07GPSQKV9 User manual

B00XBC3BF0
B01D7PG5EO
B07GPSQKV9
AmazonBasics High-Back Executive Chair
AmazonBasics Fauteuil de bureau à dossier haut
AmazonBasics Silla ejecutiva con respaldo alto
Amazon
ハイバックエグゼクティブチェア

2
English. . . . . . . . . . . . . . . . . . . . . . 3
Français. . . . . . . . . . . . . . . . . . . . 14
Español. . . . . . . . . . . . . . . . . . . . 25
日本語 . . . . . . . . . . . . . . . . . . . . 36
http://www.amazon.com/dp/B01D7PG5EO
http://www.amazon.com/dp/B00XBC3BF0

3
English
Instruction Manual · English
English
Contents
Make sure that the package contains the following parts:
A (3/4” bolts) (12)
C (Wrench) (1)
Back cushion (1) Seat cushion (1) Arms (2)
Seat plate (1) Lift (1) Star base (1)
Casters (5) B (Plastic caps) (8)
AmazonBasics High-Back Executive Chair

4
Assembly Instructions
Step 1: Turn the star base upside down, then press the casters into the holes at the end of each
base leg.
Step 2: Turn the star base upright and insert the lift into the center hole of the star base. The lift
cover should be placed over the lift.

5
Step 3: Align the seat plate over the pre-drilled holes underneath the seat cushion. Make sure
that the front of the seat plate is facing the front of the seat cushion.
Attach the seat plate to the seat cushion using four(A) bolts. Tighten all the bolts with the
wrench , being careful not to miss-thread the bolts or damage the seat.
FRONT
FRONT
A
C
(C)

6
Step 4: Turn the seat cushion upright and align the center hole of the seat plate over the lift,
then push the seat cushion down onto the lift firmly until the connection is secure.

7
Step 5: Attach the arms to the seat cushion with four (A) bolts, using the wrench .
Note: Arm rests are labeled with an "L"
(left) or "R" (right) to show which sides
they should be placed on.
A
C
(C)

8
Step 6: Lay the back cushion on the seat of the chair with the top of the cushion toward the
front.
Attach the back cushion to the arms by inserting two (A) bolts in the lower holes with the
wrench (C). Do not tighten the bolts fully.
A
C

9
Step 7: Rotate the back of the chair up, then secure it with the top two (A) bolts. Fully
tighten all the bolts.
A
C

10
Step 8: Press the plastic caps (B) into the arm holes to cover the bolts.
Caution:
For your safety, before using your chair, make sure that all of the bolts are fully tightened.
Keep the enclosed wrench and check the bolts periodically to make sure they remain securely
tightened.
B