American Standard ACTICLEAN 7381557-400.0070A User manual

ACTICLEAN™
---------------------------------------------------------------- 1----------------------------------------------------------------
Product names listed herein are trademarks of AS America Inc. 7302224-100 (06/16)
© AS America Inc. 2014
FLUSH VALVE ASSEMBLY
P/N: 7381557-400.0070A
• All trim components including tank-to-bowl
gaskets, washers, nuts, clevis pin, and hair
pin
• Includes a nut tightening tool
TO REMOVE FLUSH VALVE ASSEMBLY:
• Turn off water supply; flush toilet (remove all
water from the tank)
• Remove tank nuts; do not remove second set
of tank nuts (see FIGURES 1 and 2)
• Remove tank from bowl and lay tank on flat
surface on backside to prevent scratching;
no need to remove trip lever
• Remove hair pin and clevis pin from the RED
trip lever arm (see FIGURE 3); this frees the
yoke from the red arm
• Remove hair pin and clevis pin from the
BLACK trip lever arm (see FIGURE 3); this
frees the bead chain from the black arm
• Pull the refill tube from the overflow funnel
connection
• Grab and remove tank to bowl gaskets from
the underside of the tank
• Take the included tool and remove tank to
bowl nut by turning counterclockwise
• Remove friction washer
• Remove flush valve assembly from the
inside through the top of the tank
FIGURE 1
FIGURE 2
FIGURE 3

ACTICLEAN™
---------------------------------------------------------------- 2----------------------------------------------------------------
Product names listed herein are trademarks of AS America Inc. 7302224-100 (06/16)
© AS America Inc. 2014
FLUSH VALVE ASSEMBLY
P/N: 7381557-400.0070A
TO RE-INSTALL:
• Install the valve, orient valve assembly so
overflow funnel is positioned towards the
back of the tank (see FIGURE 4)
• Hold the valve in the tank with one hand
• Place friction washer over threads on bottom
of the tank (see FIGURE 5)
• Attach nut; orientation tabs must face away
from tank (see FIGURE 6)
• Use supplied tool to tighten nuts to tank
bottom, at least one hand tight
• Apply and work gaskets around the 6
retaining tabs on the nut so the inner rib on
the gasket is captured between the tabs and
the tank. Note the inner rib on the gasket is
offset to one side. Be sure to orient the
gasket with the inner rib towards the bottom
of the tank. When done correctly, the gasket
should not be compressed and should be
held in place while installing the tank.
• Re-mount tank to bowl (see FIGURE 1)
• Re-attach the refill tube into the overflow
funnel connection of the new valve
• Insert the BLACK trip lever arm in to the
chain coupler of the bead chain; push the
clevis pin through the arm and insert the hair
pin (see FIGURE 3)
• Insert the RED trip lever arm in to the yoke
of the teeter bar; push the clevis pin through
the arm and insert the hair pin (see FIGURE
3)
FIGURE 4

ACTICLEAN™
---------------------------------------------------------------- 3----------------------------------------------------------------
Product names listed herein are trademarks of AS America Inc. 7302224-100 (06/16)
© AS America Inc. 2014
FLUSH VALVE ASSEMBLY
P/N: 7381557-400.0070A
COMPLETE BY ADJUSTING THE SETTINGS:
• Depress trip lever handle all the way (A).
• Adjust screw on the teeter bar (B) so rear frame(C) touches the frame stop (D).
• Return trip lever handle (A) to rest position.
• Make sure hook (E) is fully engaged under tab on valve body(F), if not, slightly adjust screw to
make sure hook isengaged.
• Turn water supply on; adjust water level to specified dimension on tank liner sticker and flush
5 times toprime.