AMS AS5601-SO_EK_ST User manual

AS5601-SO_EK_ST
Evaluation Kit
Quickstart Guide

2
Step 1: Kit Content
This kit contains following material listed in the table
below. Additional information about material can be
found on our webpage.
No.
Item
Info
1
USB I&P Box
Programming and Interface
Box (Includes USB Drive,
USB Cable, 10way cable,
USB I&P Box)
2
AS5601-
SO_EK_AB
Adapterboard including
reference magnet
3
RMH05-DK-
XX-1.0
Rotary Magnet Holder with
Knob
Step 2: Install the AS560X Demo Software
The Software is located on the USB drive that comes
with the USB I&P Box or it can be downloaded from
our webpage. After Installation run the software.

3
Step3: Assemble the Hardware Setup
Step4: Using the software
Following steps are required to perform a
configuration and to read-out the AS5601. Read the
software user manual for details.
A. Perform the desired configuration
B. Perform the required angle programming.
C. Verify the results

4
Support
Download the latest manual from the product webpage:
http://www.ams.com/eng/Support/Demoboards/Position-Sensors/Rotary-
Magnetic-Position-Sensors/AS5601-Eval-Kit
Note:
This Programmer is for LAB Evaluation only.
Do not use it as a Production Programmer!
Contact Information
Headquarters
ams AG
Tobelbader Strasse 30
8141 Unterpremstaetten
Austria
T. [phone]
For Sales Offices, Distributors and Representatives, please visit:
http://www.ams.com/contact