Angler COL-1212 User manual

INSTRUCTIONS
Cylinder Omni Softbox

2
Overview
COL-1212
Bottom diuser
Cylinder
Adjustable
corners
Carry pouch
Secure straps
Touch-connect strip

3
COL-BOW
Bottom diuser
Carry pouch
Drawstring
Cylinder

4
COL-CYL
Bottom diuser
Carry pouch
Cylinder
Secure straps

5
COL-1212
For the Luxli Timpani and Other 1×1 Light Fixtures
Preparing the Light Fixture
If the fixture has height adjustment knobs, raise fixture’s height so it
sits above the bottom of the yoke.
Some 1 × 1 fixtures have two sets of side knobs for tilt and height
adjustment. Adjust the height so the tilt knobs are in the middle of
the fixture. This will make it easier to fit the softbox onto it.
Attaching the Softbox
1. Align the COL-1212 so the straps
are on the side of the fixture.
2. Open the adjustable corners.
1
2

6
3. Spread the flaps open, and fit the
opening of the COL-1212 on the
fixture. Make sure the black inner
border rests on the front of the
light.
4. Secure the straps by stretching
them across the back of the fixture
and attaching them to the touch-
connect strips on the opposite side.
5. Fold the flaps over the corners of
the fixture and secure them with
the touch-connect strips.
3
4
5

7
1. Remove the reflector from the
Bowens mount.
2. Open the zipper at the bottom of
the cylinder, and insert the reflector
through the opening.
3. Attach the reflector to the light.
The reflector will hold the cylinder
in place.
1
2
3
COL-BOW
For Light Fixtures with Bowens Accessory Mounts

8
1. Align the cylinder so the notches
are on the sides of the fixture.
2. Fit the opening of the cylinder over
the fixture.
3. Secure the straps to the touch-
connect pads.
COL-CYL
For Round LED Light Fixtures
1
2
3

9
Shaping the Light
Removing the Bottom Diuser
Unzip and remove the bottom panel to
allow the light to shine directly down
without diusion.
Attaching the Skirt to the Cylinder
The Angler COL-CYLSK reversible skirt
(sold separately) limits light spread on
one side of the cylinder.
Use the included clips to attach the
skirt to the top and bottom rims of the
cylinder.

10
Warnings
Please read and follow these instructions, and keep this
manual in a safe place.
For use only with LED fixtures.
Use caution when unfolding this product. Unfold in an area
large enough to accommodate the full size of the cylinder.
Do not unfold around breakable objects.
Do not machine wash.
All photos are for illustrative purposes only.
SPECIFICATIONS
Material Cylinder: Polyester fabric
Skirt: Polyester (black/silver)
Dimensions Height: 28 in. (71.1 cm)
Diameter: 18 in. (45.7 cm)
Shape Cylindrical
Compatibility COL-1212: 1 × 1 LED Lights
COL-BOW: Lights with Bowens mount
COL-CYL: Round LED Lights
Weight COL-1212: 12.3 oz. (349 g)
COL-BOW: 9.6 oz. (272 g)
COL-CYL: 9.3 oz. (263 g)