ANTAIRA BTS-1000A User manual

BTS-1000A
Bluetooth to RS-232 Converter
Quick Installation Guide
Antaira Technologies, LLC
Website: http://www.antaira.com
eMail: [e-mail]

Bluetooth to RS-232 Converter
2
1. Plug power adapter to the converter and connect to PC’s COM1
port (COM port Selectable).
2. Run the BT1 program (BT RS232 Config Tool V1.00).
3. Click the Connect button on the BT RS232 Tool program and
with a needle or paperclip, press the side button located on the
Bluetooth converter to get into setup mode.
4. When the Read button turns visible, it is in setup mode.
5. Click the Read button. You can read the converter default
parameters.

Bluetooth to RS-232 Converter
3
6. Change the parameter information then click the Write button
on the BT RS232 Tool program. You can save the parameters
to Bluetooth converter.
7. Turn off the power, close the BT RS232 Tool program, and
power on the converter again. If pairing is established (the green
LED will stay lit), the Bluetooth converter is now in transmit data
mode.
8. In transmit data mode, the red and green light will continuously
light.

Bluetooth to RS-232 Converter
4
DSUB-9 PIN definition
Pin 1> NC Pin 6> DTR (data output)
Pin 2> TXD (data output) Pin 7> CTS (data input)
Pin 3> RXD (data input) Pin 8> RTS (data output)
Pin 4> DSR (data input) Pin 9> DC 5v power (in)
Pin 5> GND Default Value: 9600,N,8,1
Remark: RX / TX has been CROSSED OVER
PIN code: 1234