Anzzi Key L-AZ097 User manual

ITEM: L-AZ097**
INSTALL & OPERATION MANUAL
V1.0
ANZZI SINGLE-HANDLE LAVATORY FAUCET
DON’T WAIT!
REGISTER NOW!
Register your product within 90 days to ensure your product is
recognized as an purchase and is for warranty
coverage.
in the registry card (Pg. 2) or register
at www.swcorp.com/register
.
LEAD FREE
NSF/ANSI/CAN 61

Have questions? Call us at 305-614-4070 or visit us at www.ANZZI.com

1
Dimensions
11.65″
[296mm]
1.38″
[MAX35mm]
4.72″
[120mm]
5.61″
[142.5mm]
8.8″
[224mm]
1.42″
[35mm]
You may need:
PG.1

Parts list
PART NAMENO.
1
2
3
4
5
6
Handle
7
8
9
Index
10
Screw
11
12
13
14
15
16
17
18
Shank
Trim cap
Base
Retainer
Body
Cartridge
Washer
Metal gasket
Lock nut
Screw
Filter
Flexible hose
1
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
2
3
22
21
O-ring
O-ring
Connector
19
20
Flow regulator
21
22 O-ring
Flow restrict re
Copper tube
PG.2

Installation Instructions
4
1. 2.
PG.3
Loosen the locknut (18) and remove the washer (16) ,
metal gasket(17).
Slide the O-ring (15) over inlet tubes and shank. Position
the faucet and gasket on the sink. Option: If sink is
uneven, use silicone under the gasket.
3. 4.Place washer (16),metal gasket (17) over the shank
under the sink. Install the locknut (18) and hand tighten
it, then secure the faucet by tightening the screws of
the locknut (18).
NOTE: Supply valves are not included and must be
purchased separately.
Connect the flexible hoses to the water supply valve
(not included) and copper tubes, and tighten it with
adjustable wrench. DON'T OVER TIGHTEN！
Caution: make sure to connect the hot and cold flexible
hose to supply valves correctly.

Checking and testing
Push Pop-Up Installation
Specificaition
A.
B.
C.
Turn on the faucet and check that the water is flowing freely and steadily.
2.
1.
B
Washer
Plastic washer
Lock nut
ody
Gasket
PG.4
If the water flow is weak, turn off the faucet, disconnect the hoses from the faucet and check the filter. Use pliers or
a sharp pin to remove the filters for cleaning. Then place the filters back and reconnect the hoses to the faucet.
Check all connection points (see the arrows in fig. 2) for any leakage. Tighten if necessary. BUT DON’T OVERTIGHTEN!
Install the pop-up body and gasket into the
drain hole.
Install washer, plastic washer and lock nut from
below. Secure the pop-up by tightening the
lock nut.

Care and Maintenance
3. Install the pipe with the gasket inside.
Body
Gasket
Outlet pipe
PG.5
Daily care and cleaning are required to keep the product shining and functional.
ONLY USE Regular soap and warm water to wash the faucet. Then dry off with a
soft cloth.
NEVER USE Any strong cleaners. Avoid using any harsh chemicals. And never
scrub using abrasive sponges or materials.