Aosom CHILDREN'S Pedal Engineering Vehicle User manual

1
ASSEMBLY INSTRUCTION
IN230700271V01_US_CA
370-299V00
EN
CHILDREN'S Pedal Engineering Vehicle
IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY
* WARNING: Certification Age: 18+ months; Max weight: 25 kg.

2
K1
J1
Main body handle braker Road Roller
Pushdozer head Road Roller/Pushdozer arm Excavator head
Excavator arm Screw (4x12mm) Screw (4x12mm)
Steering wheel Nut (M5) Screw (5x25mm)
Note:
Some parts are under the seat, please take out them under seat before assembly.
Assembly tools required:
Screwdriver (not included)
LM2
Anti-tipping support

3
WARNING:
1. CHOKING HAZARD—Small parts.
2. Only allowed for adults to install, keep children away.
3. To be used under the direct supervision of an adult.
4. Just only allow one child to use.
5. Please use on a flat and clean surface. Never use near steps, sloped driveways, hills
roadways, alleys, swimming pool areas, road, on grass or wet surfaces or other
bodies of water.
6. Before driving toy car each time, adult should inspect screws of every parts, please
tighten the screw cap if any looseness. secure all fasteners before every ride.
7. Always wear shoes and suitable protective equipment. always wear a local standard
approved helmet while riding, with the chinstrap securely fastened.
8. Do not ride the product at dusk, at night or at times of limited visibility.
9. Always comply with local laws and regulations.
MAINTENANCE & CARE
A. Keep all instructions and parts relating to this product for future reference.
B. Regularly check for damage and that all screws are securely tightened.
C. Check that the seat is securely fastened.
D. Lubricate the chain as often as required.
Assembly Instruction
Pushdozer head assembly
NOTE: Some parts under the seat, please take out them under seat before assembly.
Press the lock on the pushdozer head and insert it to the pushdozer arm as picture
shown.
NOTE: The road roller and pushdozer head share with one arm, if use the pushdozer
head, need to disassembly the road roller.

4
Assembly Instruction
Road roller assembly
Press the lock on the road roller and insert it to the road roller arm as picture shown.
NOTE: The road roller and pushdozer head share with one arm, if use the road roller,
need to disassembly the pushdozer head.
Excavator arm hand bar assembly
Please insert the left and right hand bar to excavator arm as picture shown.

5
Assembly Instruction
Excavator assembly
Screw
(4x12mm)
Assembly the excavator head and fasten with 2 screws for two sides as picture
shown.
Front Anti-tipping support assembly
Insert the anti-tipping support and fasten with 2 screws as picture shown.
Screw
(4x12mm)

6
Assembly Instruction
Rear Anti-tipping support assembly
Screw
(4x12mm)
Insert the anti-tipping support and fasten with 2 screws as picture shown.
Steering wheel assembly
Screw
(5x25mm)
Nut (M5)
Place the steering wheel into the steering column. Tighten the screw with nut.

7
Assembly Instruction
Assembly Pushdozer head/Excavator head/Road roller
NOTE: The road roller, pushdozer head and excavator share with one main body.
One time can only use one of them as you like.
Press the lock on the pushdozer arm and place it to the main body as picture shown.
If use the road roller or excavator, need to disassembly the pushdozer head. Use the
same method to assembly the road roller or excavator.
Battery Installation
1. For longer life, use alkaline
batteries.
2. Loosen the screw into the battery
compartment door with a Phillips
screwdriver and remove the door.
3. Insert two, new AAA (LR03) alkaline
batteries.
4. Replace the battery compartment
door and tighten the screw. Do not
over-tighten.
Horn Music
Protect the environment by
not disposing of this product
with household waste
(2012/19/EU).
Check your local authority
for recycling advice and
facilities.
Road Roller
Excavator
Pushdozer

8
Parts Diagram
No. Part
7.Pushdozer head
8.Pushdozer/Road roller arm
9.Seat
10.Steering wheel
11.Hand bar
Quantity
1
1
1
1
2
No. Part
1.Excavator head
2.Excavator arm
3.Front support
4.Main body
5.Anti-tipping support
6.Road roller
Quantity
1
1
1
1
2
1

9
ASSEMBLAGE D’INSTRUCTIONS
370-299V00
FR
VÉHICULE À PÉDALES POUR ENFANTS
IMPORTANT : A LIRE ATTENTIVEMEN ET A CONSERVER POUR VOUS
Y REFERER ULTERIEUREMENT
* ATTENTION: Âge de certification: 18+ mois; Poids maximum: 25 kg.
IN230700271V01_US_CA

10
K1
J1
Corps principal Barre de guidage Rouleau
compacteur
Tête de bulldozer
Bras du Rouleau
compacteur / bulldozer Tête d'excavatrice
Bras d'excavatrice Vis (4x12mm) Vis (4x12mm)
Volant Écrou (M5) Vis (5x25mm)
REMARQUE:
Certaines pièces se trouvent sous le siège, veuillez les retirer avant l'assemblage.
Outils d'assemblage requis:
Tournevis (non inclus)
LM2
Support anti-
basculement