AQUAMAXX ConeS DRC-3 User manual
www.aquamaxxaquariums.com
www.aquamaxxaquariums.com
AquaMaxx ConeS
DRC-3 Controllable
In-Sump Protein
Skimmer
User’s Manual
Shark
DC PUMP
1Questions? Email [email protected]
Footprint
Height Pump Motor
Pump Power Consumption
Recommended Water Level
Outlet Size
Top Clearance Required
Gallon
Rating
Chamber Diameter
Light Bioload
Heavy Bioload
15.3” x 9.4”
8”
23.8” Shark 3000 DC
23 Watts
1 1/2”
8-10”
Approx. 1/2”
Up to 270
gallons
Up to 450
gallons
AquaMaxx ConeS DRC-3 Controllable In-Sump Protein Skimmer
1. Shark 2000 DC Pump
2. Pump Venturi
3. Pump-Stabilizing Plate & Screw
4. Pump Connector Pipe
5. Airline Tubing
6. Air Silencer
7. Bubble Plate / Diuser
8. Skimmer Body
9. Skimmer Base & Body Screws
10. Outlet Pipe
11. Adjustment Valve
12. Collection Cup
13. Elbow Drain
14. Pump Controller
15. Pump Power
2Questions? Email [email protected]
Installation Guide
Press-t the venturi into the pump.
Connect the water outlet of the needlewheel pump to the skimmer body using the yellow silicone
tube.
Install the air silencer. Attach the air silencer to the skimmer body by nger-tightening the plastic
thumbscrew in a clockwise motion.
Connect the air silencer to the pump air intake using the yellow silicone air line tubing.
Attach the drain elbow to the collection cup, using a zip tie to secure if desired.
3Questions? Email [email protected]
Installation Guide
4Questions? Email [email protected]
Installation Guide
Ensure the o-ring is securely in place on the skimmer body, then install the collection cup by
twisting it clockwise onto the skimmer body.
O-ring
Connect the DC controller to the pump and power supply.
Shark
DC PUMP
5Questions? Email [email protected]
Operation Guide
The recommended water level range for this skimmer is 8-10 inches. For proper performance of
the Quick-Precise adjustment valve, the water in your sump must not be any higher than 10”.
Use the quick-precise adjustment valve to alter the water level within the skimmer body.
Use the DC controller to adjust the pump ow speed for further ne tuning.
Turning the valve counter-
clockwise will open the outlet
pipe, lowering the water level
within the skimmer body.
Lower the pump ow rate using
the downward arrow button
on the DC controller.
Turning the valve clockwise will
close the outlet pipe, raising the
water level within the skimmer
body.
Shark
DC PUMP
Raise the pump ow rate using
the upward arrow button on
the DC controller.
6Questions? Email [email protected]
Operation Guide
As a starting point, it is recommended to adjust the water level within the skimmer body to where
the collection cup meets the neck.
It may require 2-4 weeks for the skimmer to reach optimal performance due to tiny amounts of
oil or remnant leftover from the manufacturing process. The skimmer’s performance may be
erratic during this period; be sure to allow ample time for the skimmer to break in prior to making
any major adjustments.
Regular maintenance of the pump will ensure a long life and maximum performance. You can
clean the pump and its components by soaking in a general citric acid solution once every 3
months.
The collection cup should be cleaned frequently with a sponge and warm water.
Shark
DC PUMP
025
Watt
1.0
Amp
03551
RPM
In case of power failure, the controller will memorize
the last speed setting and resume at that power upon
restart.
Tap the power button once to pause the skimmer.
Tap the upward arrow button once to resume skimmer operation.
The LCD display will show power consumption,
current, RPMs, and speed indicator bars.
The upward and downward arrows can be used to
raise or lower the pump power in 2 watt increments.
AquaMaxx warrants all AquaMaxx products to be free from manufacturing defects for one year from
the original purchase date when purchased through an authorized AquaMaxx retailer. This warranty
does not cover any damages caused by misuse, neglect, alterations or improper handling / transport /
maintenance / installation. Physical damages are not covered by warranty. AquaMaxx does not cover
personal injury, personal loss, or other damages associated with the use of our products. In order to
request warranty service, please email us at info@aquamaxxaquariums.com. A purchase receipt is
required for any warranty service. Products requiring warranty service must be returned to AquaMaxx.
You are responsible for the cost of shipping a warranty claim to AquaMaxx and any damages that may
occur during transit. Once a returned product has been inspected, it will be repaired or exhanged at
our discretion and returned to you. International and / or expedited shipping are not covered under
your AquaMaxx warranty.
7Questions? Email [email protected]
Operation Guide
Table of contents
Other AQUAMAXX Water Filtration System manuals
AQUAMAXX
AQUAMAXX ConeS DRC-2 User manual
AQUAMAXX
AQUAMAXX ConeS FC Series User manual
AQUAMAXX
AQUAMAXX Puratek Deluxe User manual
AQUAMAXX
AQUAMAXX ConeS DCQ Series User manual
AQUAMAXX
AQUAMAXX CTECH T-2 User manual
AQUAMAXX
AQUAMAXX HOB-1 User manual
AQUAMAXX
AQUAMAXX FR-SE User manual
AQUAMAXX
AQUAMAXX FR-1ES User manual
AQUAMAXX
AQUAMAXX TS-2 User manual
AQUAMAXX
AQUAMAXX Cone-S Q Series User manual
Popular Water Filtration System manuals by other brands
Jandy
Jandy CS150 Installation and operation manual
Kessel
Kessel LW 400 installation instructions
Water Filters Australia
Water Filters Australia K-WFADUOGN owner's manual
Watts
Watts Dormont Snap'N Go instructions
Eaton
Eaton LOEFFLER FILTRATION HAYFLOW Important installation instructions
Sharp
Sharp FZ-560HF Replacement parts
