AQUAMAXX FR-SE User manual

FR-SE
Installation Guide [email protected]
www.aquamaxxaquariums.com
The hose barbs could be set in different positions by unscrewing the
hose barbs fasteners beneath the lid, then pressing the hose barb
upward out of their hexagonal recess.
2( Only if you need to set the hosebarbs in different position )
1Loosen the thumb screws*4 to release the lid.
Includes:
Recommendations
Filling Your Media
Main Body *1
Set of Filter Sponges
Hose Holder
1/2” (13 mm) hose barbs *2
While we take great care to keep any contaminates away from our products during
assembly, please take a moment to clean the reactor and plumbing before attaching to
your tank. Only clean your reactor with warm water. Never clean Acrylic with alcohol based
products. Use caution when handling as acrylic scratches easily.
Please keep in mind that a media reactor is intended to be a bypass filter, and is not
designed to handle the complete flow and pressure requirements of a large aquarium
system.
GFO,Carbon and Biopellet Media Reactor
1.
2.
Some media (such as phosphate control products) is not designed to be aggressively
fluidized in a reactor – please read the instructions of your media carefully.
The reactor should be cleaned out every time that the media is replaced ensuring that there
is no media below the bottom plate.
3.
4.
O-ring
*2 *1
Unique design of inlet and outlet could be set in multiple ways,
could be suitable for any tubing.
One and Only Multiple ways to set!

3
Remove the upper media plate and the O-ring.
Install the set of filter sponges.
Make sure the sponge is all the way at the
bottom of the reactor, flush against the
plate – otherwise the media may leak past
it when filling
4
67 5
5
Now you can fill in your media,
but watch out not to fill into the
central tube. You can temporarily
block the top of the central tube
to stop media from going down
the central tube.
9
Replace the reactor lid, and gently tighten the thumbscrews.
CAUTION: DO NOT OVER TIGHTEN THE SCREWS.
Connect the Inlet and outlet hose to Inlet and outlet fitting of the lid.
8Install the hose holder
AquaMaxx warrants all AquaMaxx products to be free from manufacturing defects for one year from the original purchase date when purchased through an authorized
AquaMaxx retailer. This warranty does not cover any damages caused by misuse, neglect, alterations or improper handling / transport /maintenance / installation. Physical
damages are not covered by warranty. AquaMaxx does not cover personal injury, personal loss, or other damages associated with the use of our products. In order to
request warranty service, please email us at [email protected]. A purchase receipt is required for any warranty service. Products requiring warranty service
must be returned to AquaMaxx. You are responsible for the cost of shipping a warranty claim to AquaMaxx and any damages that may occur during transit. Once a
eturned product has been inspected, it will be repaired or exchanged at our discretion and returned to you. International and/or expedited shipping are not covered under
your AquaMaxx warranty.
the reactor should be filled no
more than 2/3 full to allow the
media room to move around.
With heavy or fine media, you
may need to add less.
Warranty
Install the rest of the set of filter sponges (not
necessary if media diameter is above 2mm)
and the upper media plate. The plenum may
fit snugly, please use caution when sliding it
on.
Inlet
(connects to central tube)
Outlet
If the diameter of your media is above 2mm, you can skip to
Because the set of filter sponges is not necessary for bigger media,
please read the instructions of your media carefully.