AQUATECH P Series User manual

P Series Lens Port
Instruction Manual
Thank you for purchasing this AquaTech
Lens Port. All AquaTech Sport Housings are
equipped with our Thread lock Port system
and particular attention should be paid to
the installation and removal process listed
on the rear of the document.
Please note that this P Series Lens Port
is designed to work with the Delphin and
Elite model’s of the Sport Housing range
and selected other Sport Housings which
clearly state use with the P-series Lens
Ports.
OVERVIEW:
• Optically correct acrylic element
• Mechanically sealed, no adhesives used
• Flat port elements are SAR coated
(scratch abrasive resistant)
• Element replaceable

INSTRUCTIONS:
Place the port over your lens which should be
attached to your camera and inside the Sport
Housing. Align the thread and tighten your
port all the way down rmly to ensure that it
has an even seal with the compression seal
O-Ring in your Sport Housing.
Remember to tighten your ports
very tight with both hands to
ensure a good seal on the front
O-ring between your Lens Port and
Sport Housing.
To remove your port face the front element
downwards. Water can become trapped in the
port threads and, if removed facing upwards,
can fall into the Sport Housing and your
camera and lens. Unscrew the port and remove
from Sport Housing.
Do not leave your Lens Port on your Sport
Housing when not in use. They should be
removed after each use to insure product
longevity.To clean simply use fresh cold water
and a damp cloth. Neoprene soft covers are
available for all ports and a great way to
protect your element and port when not in use.
If you do need further support with this
item please contact Aquatech via email on
[email protected]