Architectural Mailboxes 2507 User manual

Wall Mount Mailbox | Model 2507
MOUNTING INSTRUCTIONS
R
One Drill
x 4, screws
IMPORTANT! This
mailbox is intended to be
mounted under an eave or
another protected area.
Tools (not included)
Hardware (included)
x 4, plastic
anchors
1Using the guide on the back of these instructions,
mark the wall at the center of each crosshair. Use a
level to ensure a straight installation (optional).
2Drill into the wall at each marked location. Use a
1/4" drill bit for brick or other masonry wall. Use a
1/16" drill bit for wood wall.
One Drill Bit
1/4” masonry bit or 1/16”
wood bit
x4
1/4" masonry bit
- or -
1/16" wood bit
3Skip this step if installing into wood.
Insert the included plastic anchors into the drilled
holes. Gently tap them in if necessary.
4Insert the screws into the top two drilled holes and
secure with a screwdriver. Hang the mailbox onto
the secured screws using the top eyelet holes on
the back of the mailbox.
x4
One Phillips Screwdriver
5While the mailbox is hanging on the top screws,
insert the remaining two screws into the bottom
holes and secure with a screwdriver.
© 2020, Architectural Mailboxes, LLCRev. E
Questions, Comments, Concerns?
[email protected]
www.architecturalmailboxes.com
Find us on social media!
@archmailboxes
Need keys? Visit us at...
www.architecturalmailboxes.com/keys

© 2020, Architectural Mailboxes, LLCRev. E
INSTALLATION
TEMPLATE
Use this guide to mark the hole locations -
make sure the page is level before marking.