Argos Ellie 257/8028 User manual

Assembly Instructions -Please keep for future reference 257/8028
Dimensions
Width - 90cm
Depth - 54cm
Height - 170cm
Important - Please read these instructions fully before starting assembly
Version 1 Date: 14/05/14
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
Ellie Wardrobe and Storage

1
Safety and Care Advice
Important –Please read these instructions fully before startingassembly
Note: if required the next
page can be cut out and used
as reference throughout the
assembly. Keep this page with
these instructions for future
reference.
• Check you have all the
components and tools listed on
the following pages.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• During assembly do not stand
or put weight on the product,
this could cause damage.
• Assemble the item as close
to its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Care and maintenance
Skin contact: Remove
contamination by washing with
soap and water. This procedure
should also be followed prior to
eating and drinking.
Eye contact: Rinse immediately
with clean water for 15 minutes
and seek medical advice.
If swallowed: Seek medical
advice immediately.
Glue safety - Take care when using glue, please follow the advice below
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts
• Regularly check and ensure
that all bolts and fittings are
tightend properly.
Handy Hints
• Do not use this item if any
components are missing or
damaged.
• Parts of the assembly will be
easier with 2-3 people.
• Argos Ltd. MK9 2 NW. • This product is intended for
children in the age range of
7-12 years.
• Maximum load: 5 kgs for
each shelves.
• Assembly of this product must
be carried out by a competent
adult.
IMPORTANT: RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
• During assembly children
should be kept away from the
product due to possible risk of
injury.

Components -Panels
Please check you have all the panels listed below
If you have damaged or missing components, call the
Customer Helpline:
Argos = 0345 6400800
2
Top right panel
(46 x 53.5cm)
1Top left panel
(46 x 53.5cm)
2
Right side panel
(50.3 x 160cm)
5Left side panel
(50.3 x 160cm)
6Left side leg
(3.5 x 160cm)
8Right side leg
(3.5 x 160cm)
7
Middle panel
(49.7 x 118.2cm)
9Door panel
(45 x 117.3cm)
10
Left side shelf x 2
(49.6 x 29.2cm)
12
Top back panel
(77.6 x 34cm)
13
Top door panel
x 2 (37 x 33.4cm)
14 Front panel
(75 x 13cm)
15
Back panel
(77.6 x 120.3cm)
11
Back support
(75 x 14.5cm)
16
Top shelf
(75 x 51.8cm)
4
Bottom panel
(75 x 51.8cm)
3
Pilot holes
for guidance
only
Pilot holes
for guidance
only Pilot holes
for
guidance
only
Pilot holes
for guidance
only
Pilot holes
for guidance
only

3
Please check you have all the fittings listed below
Ruler - Use this ruler to help correctly identify the screws
Tools required
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 110 115 120 125 130 135 140 145 150 155 160 165 170
105
Components - Fittings
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
0 1 2 3 4 5 6
Phillips screwdriver
(medium & large)
Flatblade screwdriver
(medium)
Small
hammer
Ruler/tape
measure
Drill
Eye protection
(when using a
hammer or glue)
7mm Suitable drill bit
(for use with wall plug)
The screws length is measured from the head to the point (30mm screw shown).
30mm Dowel x 54
A
Rail Support x 2
E
Foot x 1
B
39mm Locking pin x 16
H
14mm Screw x 3
C
Door hinge x 7
I
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
15mm Screw x 46
F
Door pad x 2
D
15mm Locking nut x 16
K
50mm Screw x 10
G
30mm Screw x 6
J
Clothes rail x 1
M
Nail x 31
N O
Handle x 3
L
PQ
(42 screws are included in
the Hinge bag (I))
Wall plug x 1 Wall strap x 1
(This screw is
included in the
wall strap bag)
x 1
Glue x 1

A
O
E
F
F
9
F
E
3
4
A
A
AA
A
A
A
A
A
A
A
A
4
Assembly Instructions
Step 1
a:
b:
Continued on next page.
Attaching shelves
a: Place a small amount
of Glue into the dowel
holes.
O
A
Insert Dowels into the
Bottom panel and
Top shelf .
3
4
9
b: Use Screws to fix
Rail support onto the
Middle panel .
F
E
O

A
O
B
G
G
G
G
G
9
A
A
A
A
A
A
12
12
12
9
G
G
G
G
C
3
3
4
Finished front edge
Finished front edge
Finished front edge
c:
5
Assembly Instructions
Step 1 - continued
d:
e:
c: Use Screws to fix
Bottom panel and Top
shelf onto the Middle
panel .
G
3
9
4
d: Place a small amount
of Glue into the dowel
holes.
O
Use Screws to fix the
Foot onto the Bottom
panel .
C
B
3
e: Use Screws(4 pcs)
to fix Left side shelf
onto the Middle panel .
G
12
9
A
Insert Dowels into the
Left side shelf .
12
O

6
A
A
A
A
A
A
A
H
H
H
H
H
H
H
H
H
A
O
H
5
A
A
A
A
A
A
A
H
H
H
F
E
H
F
E
A
O
A
Insert Dowels into the
Left side panel .
6
a:
b:
6
Continued on next page.
Assembly Instructions
Step 2
Attaching side panel
a: Place a small amount
of Glue into the dowel
holes.
O
Screw 8 Locking pins
into the Left side panel
.
6
Note: Insert locking pins
as far as shown.
Do not over tighten.
H
A
Insert Dowels into the
Right side panel .
5
b: Place a small amount
of Glue into the dowel
holes.
O
Screw 4 Locking pins
into the Right side panel
.
5
Note: Insert locking pins
as far as shown.
Do not over tighten.
H
5
Use Screws to fix Rail
support onto the Right
side panel .
F
E
O
O

c:
d:
7
Step 2 - continued
Assembly Instructions
c: Fix Door hinges
‘back plates’ onto Left
side panel and Right
side panel using
Screw .
6
5
d: Place a small amount
of Glue onto the joint’s
surfaces.
O
Then carefully locate the
Left side leg onto the
the Left side panel and
Right side leg onto
the Right side panel .
8
7
5
6
F
F
6
I
IF
I
5
F
F
F
I
I
I
F
I
F
I
F
I
5
6
7
8
O
O
I
F
O
5 6
6
8
5
7

A
O
Attaching the unit
16
AA
A
A
A
A
A
15
A
A
A
A
A
A
16
5
6
4
K
K
K
K
K
K
K
3
12
12
8
Step 3
Assembly Instructions
15
16
Attaching front panel
and back support
Step 4
Place a small amount of
Glue into the dowel
holes.
O
A
Insert Dowels into the
Front panel and Back
support .
Position Front panel ,
Back support , Left
side panel and Right
side panel onto the
unit.
Insert Locking nuts
(12 pcs) into the Top shelf
Left side shelf and
Bottom panel .
K
K
Use a screwdriver to turn
Locking nuts clockwise
to lock.
15
16
6
5
4 12
3
15
K
K
K
K
K
K
O
O

F
I
L
JJ
F
F
I
I
14
9
Step 5
Step 6
Assembly Instructions
Fitting hinges to doors
Attach Handle using
Screws .
Fix Door hinges onto
Top door panel and
Door panel using
Screws .
X 2
I
L
J
F
14
10
J
L
J
10
F
F
FJ
J
L
N
Unfinished
back surface
13
11
11
Attach Top back panel
and Back panel using
nails .
N
13
11
Fixing back panel
Important:
The unit MUST
be ‘square’ when
back is attached.

10
K
1
H
H
2
H
H
H
K
K
K
M
2
1
5
6
9
M
E
D
D
D
a: Screw Locking pins
into the Top right panel
Top left panel .
1 2
Note: Insert locking pins
as far as shown.
Do not over tighten.
H
Attaching top panel
b:
Step 7
Assembly Instructions
Unfinished
back edge
Unfinished
back edge
a:
Carefully stick the Door
pad onto the front edge
of Middle panel .
9
D
1 2
b: Attach Top right panel
and Top left panel
onto the unit.
Insert Locking nuts
(4 pcs) into the Left side
panel and Right side
panel .
K
K
Use a screwdriver to turn
Locking nuts clockwise
to lock.
6
5
Place Clothes rail onto
the Rail supports .
M
E
Tear off the protective
backing from the Door
Pads.
K

11
a: To move doors up or
down: loosen screws
shown and move doors to
suit.
b: Once doors are
aligned, re-tighten and
insert 2 Screws into
‘hinge plates’.
14
14
10
a:
I
b:
a:
Door
b:
Door
F
I
Hinge adjustmen
a: With help, slot Door
hinges onto ‘hinge
plates’.
Continued on next page.
Step 8
Assembly Instructions
Hanging door
Step 9
b: Tighten screw shown
to lock hinges in position.
Repeat
a and b for
opposite door.
See ‘Hinge adjustment’
in step 9 if the doors
need adjusting.
I
F

12
c:
Door
d:
Door
c: To move doors in or
out: loosen screw shown
and move doors to suit.
Re-tighten screws.
d: To move doors left or
right: loosen screw shown
and move doors to suit.
Re-tighten screws.
Continued on next page.
Step 9 - continued
Assembly Instructions

If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
13
Assembly Instructions
Step 10
wall
C
Q
Top panel
P
Q
QQP
Note: Wall plugs supplied are
for solid wall only.
be used for your wall, seek
professional advice if in doubt
Back panel
Assembly is complete.
It is recommended that
the unit is fixed to a wall.
With help, move the unit
into position.
Fixing to wall
Fix Wall strap to top
panel using Screw .
Mark fixing hole on wall
and remove unit.
Drill a hole and insert Wall
pulg .
Reposition the unit and fix
wall strap using Screw .
Warning:
Before drilling,
check wall for
hidden pipes
and cables.
Warning:
The unit is heavy.
Lift with care.
Note: Before use allow
the glue to dry for 24
hours and make sure the
unit is secure.
Q
C
P
Q