Argos 601/4650 User manual

Dimensions
Width - 300cm
Height - 265cm
Assembly Instructions - Please keep for future reference 601/4650
4x3M Waterproof Gazebo With 2 side Panels
Depth - 400cm
Issue 1 - 13/09/13
Important – Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the
Customer Helpline: Argos = 0345 6400800
Address: 489-499 Avebury Boulevard Saxon Gate West, Central Milton Keynes Bucks,MK9, 2NW
For further assistance please visit http://www.argos-support.co.uk

2
IMPORTANT SAFETY INSTRUCTIONS
Read all instruction before using and keep for future reference
CAUTION
Fire precautions
Read these instructions
carefully and familiarise
yourself with the procedure
before assembling the unit.
Check that you have all the
component parts following the
list on the page 3 and
familiarise yourself with each
part before proceeding.
Take all the fittings out of the
plastic bag and separate them
into their groups.
Ensure you have enough
space to lay out all the parts
before assembly.
To avoid scratching it is
recommended that you
assemble the unit on a soft
level surface.
The unit
weight approximately
17.5 kgs.
Warning:
Please lift with care.
when assembly. Please keep
children under direct supervision
of adult when using.
under windy condition.
secure the gazebo when using.
structure and should be
disassembled and stored away
after using.
until completely dry.
four persons under light or no
wind conditions.
erect in windy conditions.
from screws, nails, staples,
hooks, etc to avoid damage to
the fabric and frame.
near lights, fireplaces, gas or
electric heaters, candles,
radiators, or any other
sources of heat, fire or
flammable liquids.
around the Gazebo. We recommend
you advise no smoking while inside.
retardant cooking area and
should not be use to house
BBQs or other cooking
methods.
common sense when in use.
Safety
animals or children dispose of the
plastic bags immediately.
Cleaning
damp cloth and mild detergent, do
not use bleach or abrasive products.
Fabric cover that is not flame
retardant.

3
Components - Parts & Fittings
Please check you have all the parts listed below
A
1 x Gazebo Cover 1 x panel w/window 1 x panel
2 x Middle Joint 4 x Corner Joint
4 x Baseplate
4
1 2 3
If you have damaged or missing components, call the Customer Helpline: Argos = 0345 6400800
Components - Fittings
Please check you have all the fittings listed below
5 6
4 x Top Pole (Φ18 x 1080mm) 4 x Top Pole (Φ18 x 1095mm)
4 x Top Pole (Φ15 x 805mm)
6 x Top Pole (Φ15 x 795mm)
1 x Top Pole (Φ18 x 980mm)
8 x Support Pole (Φ24 x 1020mm)
4 x Support Pole (Φ24 x 950mm)
2 x Supplemental Pole(Φ24x1070mm)
4 x Leg Pole (Φ31 x 1045mm)
4 x Leg Pole (Φ31 x 1020mm)
Peg x 17 BGuy rope x 4
6#5#
8#7#
1#
10#
12#
2 x Top Pole (Φ15 x 765mm)
11#
2# 3#
4#
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.

4
Assembly Instructions
Step 1
Step 2
6
6
6
IMPORTANT: Because
of the size of this unit
we recommend that it
is built in the place
intended for using
NOTE: Locate the unit
on the flat Ground free
from obstruction, in a
sheltered area away
from wind and heavy
rain as they will
damage the unit.
NOTE: It would be
useful to ask someone
to help you at this step.
Stage 1 – Fitting the Support Poles
Fig.1
Fig.3
Fig.2
6
Insert Support Pole
into the Support Poles
Meanwhile, insert Support
Pole into Support
Pole .
Ensure all the poles
are fully inserted and
secure.
See fig. 1&2
Use Corner Joints
to connect the Support
Poles. Ensure all the
poles are fully inserted
and Secure.
See fig.3.
3# 4# 3#
3# 4# 3#7#
3#
3#
3# 3#
3#
3#
3#
3#
4#
4#
4#
4#
7#
7#
6
4#
3#
7#
3#

5
Assembly Instructions
Step 3
Step 4
NOTE: It would be
useful to ask someone
to help you at this step.
Stage 2 – Fitting the Top Poles
Fig.4
Fig.5
Fig.6
6
5
Insert Top Poles
into the Top Poles
Meanwhile insert Top
Poles into the Top
Poles . Ensure all
the poles are fully
inserted and secure.
See fig. 4&5
Connect the Top Poles
& to Corner joint
and Centre Connector
, then put Tube into
Centre Connector
ensuring all poles are
fully pushed into joins.
See fig 6.
Use hooks provided
at the end of pole
and pole connecting
pole -
See fig.6.
1#
10# 12#
2#
5
1#
10#
12#
10#
12#
4#8#
2#
8#
1#
2#
5
5
10#
10#
12#
10#
12#
12#
10#
12#
1# 1#
1#
1#
2# 2#
2#
8#
2#
4#
7#
6
6
6
6
7#&

Fig.7
Fig.8 6
Assembly Instructions
Step 5
Step 6
Stage 3 – Fitting the Gazebo
Insert Leg Pole into
Connect the top pole
& .
Use hools provided at the
end of pole and
connecting pole and
middle joint .
the unit. Ensure all the
poles are fully inserted
and secure.
See fig. 7.
Carefully place the
Gazebo Cover over
the assembled roof.
Then pull the Gazebo
tightly over the
assembled roof frame.
See fig.8.
NOTE: It would be
useful to ask someone
to help you at this stage.
1
10#
10#
10# 11#
4#
5#
5
11#
11#
a:Use the velcro tapes
top frame as shown
5#
5#
5#
4#
5
5#
10#
10#
11#
11#
11#
1
a:

7
Assembly Instructions
Step 7
Step 8
NOTE: It would be
useful to ask someone
to help you at this step.
Stage 4 – Fitting the Legs
4
Insert the Baseplate
into the Leg Poles
Then insert the Leg
Poles into the unit.
Ensure all the poles are
fully inserted and secure.
See fig. 9.
Attach the Gazebo
Cover’s Hooks into holes
on the Leg Poles .
Tighten by moving the
Hook to a lower hole.
See fig.12.
6#
6#
6#
JFig.9
4
4
4
4
6#
6#
6#
6# 6#
5#
Fig.10
Fig.12
Hook
4
6#

8
Assembly Instructions
Step 9
Step 10
3
2
2 3
Stage 5 – Fitting the Guy Ropes
Attach the end of the Guy
Rope to the corner of the
top cover ring on the Gazebo.
Then attach one end to the
peg and drive the Peg into
the ground.
See fig. 15. 16 and 17.
Use the same method as in
fig. 14 to fix the other Guy
Ropes.
The length of Guy Ropes
can be adjusted.
See fig.17.
Caution: Do not assemble or
disassemble during strong
winds.
Attach the Panels both
Stick the roof velcro tape with
the panels and
See fig. 20
and at the top using the
NOTE: The pegs are for
location purpose only. They
will not support the unit in
high winds.
B
Attach the D Ring into the
Baseplates .
See fig. 13.
4
Fig.14
Fig.15
Fig.16
Fig.17
B
A
B
Fig.13
4
2
3
Fig.18
Fig.20
Fig.19
Velcro tape
Velcro tapes and secure the
Panels to the Gazebo legs by
Velcro Tapes at side
See fig.18.19.
2

9
Assembly Instructions
Step 11
Stage 6 – Fitting the Peg
Important: always use this product with caution
and read the important safety instructions.
Warning: in heavy wind , if you want to leave the
gazebo outside , please remove the side panels
Assembled one is shown
as right.
See fig.23.
Assemble is complete.
NOTE: It would be useful
to ask someone to help
you at this step.
A
Insert the pegs to the
two panels at the bottom.
See fig.21.
If you need help or have damaged or missing parts, call the
Customer Helpline: Argos = 0345 6400800
Address: 489-499 Avebury Boulevard Saxon Gate West, Central Milton Keynes Bucks,MK9, 2NW
For further assistance please visit http://www.argos-support.co.uk
2
3
Fig.23
Fig.21
A
A3
A
3
A
A
A
A
A
2
3
A
Fig.22 4
4
4
4
Use the pegs to fix the
baseplates . If the
baseplate besides the
panels, the pegs first
need through fabric
buckles at the bottom of
panels, then insert to
the baseplates
A
4
4
See fig.22.