Wiring ~ Installation
Install all Handset batteries in the Handsets and connect the power packs to the
charging cradles
Place Handsets in charging cradles and charge batteries for 15 hours (1st charge
only)
Connect the power pack to the base
Connect the exchange line(s) to the socket(s) on the rear of the base
External calls
Answer a call
Press the Talk button.
Make a call
Press the Talk button and dial the required number OR
enter the number to be dialled and press the Talk button
Intercom calls
Answer a call
Press the Talk button.
Make a call
Press the INT/OK button.
Register a Handset
On an already registered Handset press down arrow until BS setting
appears
Press INT/OK
Enter the Master PIN (default is 1590)
Press INT/OK
Press down arrow until New HS appears
Enter Sub PIN (default is 1590)
Press INT/OK
Enter the Handset number to registered
Press INT/OK
You now have two minutes to complete the following procedure
On the new, unregistered handset press down arrow until Register appears
Select the correct base number (if only one base is installed it is base 1)
Handset will search for the base put in registration mode by the above steps
Handset will respond with a number (eg:003aa-001f0h)
Press INT/OK
Enter PIN (default is 1590)
Press INT/OK
System responds in approx. 5 Secs and Handset returns to idle state with the
number displayed on the LCD
Deregister a Handset
NOTE! You cannot use the handset to be deregistered in this
procedure
On another registered Handset press down arrow until BS setting appears
Press INT/OK
Enter the Master PIN (default is 1590)
Press INT/OK
Press down arrow until Remove HS appears
Enter the Handset number to deregistered
Press INT/OK
Handset will be deregistered in approx. 5 Secs
DC 209
DC 209DC 209
DC 209
Product of Aristel Networks Australia
ACN 095 422 450
Unit 1, 25 Howleys Rd.
Notting Hill Victoria
3168
