ARJO HUNTLEIGH Malibu User manual

Soak a cloth in disinfectant. Wipe all other contact
areas such as the outside of the bathtub, hand
control and the wheel chassis with the cloth.
Remove visual residue
Turn off all
functions.
Make sure the
tranVfer chair
is inside the
bathtub.
Put on protective gloves
and eye wear.
With water, shower and
rinse the bathtub, lift arm,
transfer chair, the loose
parts and all sides of the
accessories.
If the bathtub has an Air Spa system:
The automatic disinfection will start. Approximate time
for the automatic disinfection is 3–4 minutes.
30 seconds after the start of the automatic disinfection
the disinfection spray handle can be used.
Scrub all internal bathtub surfaces, lift arm,
transfer chair, the loose parts and the accessories
thoroughly.
Spray into the surface of the overflow
outlet.
Lift out the disinfection spray
handle.
2
5
9
3 4
1
6 7
15
16
14
Spray disinfectant into the bathtub until
the flow meter (A) shows correct mixing
value according to the Instructions for
use. Adjust if needed (B).
Mixing temperature 20°C (68°F).
Spray disinfectant in the drain. Scrub the
drain with a brush. Close the drain.
Spray disinfectant in the drain. Close
the drain.
8
10 11 12
13
Wet a new cloth with water and remove the
disinfectant. Occasionally rinse the cloth in
running water.
Push down the
disinfection
button
for 5 seconds.
Open the drain. Detach and place all
accessories at the bottom of the bathtub.
QUICK REFERENCE GUIDE - CLEANING AND DISINFECTION
Malibu/Sovereign
Continue with the steps on the next page
Disinfect with disinfection unit
Clean
Disinfect
Soak a cloth in disinfectant. Wipe all other contact
areas such as the outside of the bathtub, hand control
and the wheel chassis with the cloth.
18
Open the drain.
Rinse all parts with
plenty of water
having a temperature
of 25 °C (77 °F).
17
80
70
60
50
40
30
20
ArjoHuntleigh AB
Hans Michelsensgatan 10
211 20 Malmö, Sweden
www.arjo.com
Open the drain.
Rinse all parts with
plenty of water
having a temperature
of 25 °C (77 °F).
Spray disinfectant
on all internal
bathtub surfaces, lift
arm, transfer chair,
the loose parts and
on all sides of the
accessories.
Spray disinfectant
on all internal
bathtub surfaces, lift
arm, transfer chair,
the loose parts and
on all sides of the
accessories.
A
B
08.AZ.00_6EN • 09/2020 • Page 1/3

20 21
19
23 24
22
27
25
Leave to air dry.
Attach armrests and
seat. Make sure the
seat is attached.
Attach the neck pillow,
safety belt and rest of
the accessories.
26
Allow appropriate
contact time
according to the
instructions of the
disinfectant.
Allow appropriate
contact time
according to the
instructions of the
disinfectant.
Place the disinfection spray handle
back. Close the cover.
2
1
Push down the
disinfection button
for 5 seconds to end
the disinfection cycle.
If the bathtub has an Air Spa system:
Push the disinfection button and it will shorten the sequence
for the automatic disinfection cycle. Reduced time is up to
35 seconds. The LED will start flashing.
A sequence of rinsing and drying of the Air Spa system will
now start and when complete, the automatic disinfection
stops and the LED goes out.
Wet a new cloth with water and
remove disinfectant. Occasionally
rinse the cloth in running water.
Open the drain.
Rinse all parts with water
having a temperature of
25 °C (77 °F).
08.AZ.00_6EN • 09/2020 • Page 2/3
Disinfect with disinfection unit (continued)

Remove visual residue
Turn off all
functions.
Make sure the
tranVfer chair
is inside the
bathtub.
Put on protective gloves
and eye wear.
2
5
910 11
34
1
6 7 8
Open the drain. Detach and place all
accessories at the bottom of the bathtub.
Clean
Spray disinfectant in the
drain. Scrub the drain with
a brush. Close the drain.
Spray disinfectant
on all internal
bathtub surfaces, lift
arm, transfer chair,
the loose parts and
on all sides of the
accessories.
Spray into the surface
of the overflow outlet.
Scrub all internal bathtub surfaces, lift arm,
transfer chair, the loose parts and the
accessories thoroughly.
Open the drain.
Rinse all parts with
plenty of water
having a temperature
of 25 °C (77 °F).
Soak a cloth in disinfectant. Wipe all other contact
areas such as the outside of the bathtub, hand
control and the wheel chassis with the cloth.
Wet a new cloth with water and remove
the disinfectant. Occasionally rinse the
cloth in running water.
Spray disinfectant in the drain.
Close the drain.
Disinfect
Spray disinfectant on all
internal bathtub surfaces, lift
arm, transfer chair, the loose
parts and on all sides of the
accessories.
15
1312
16 17
21
19
Leave to air dry.
Attach armrests and
seat. Make sure the
seat is attached.
Attach the neck pillow,
safety belt and rest of
the accessories.
20
Allow appropriate
contact time
according to the
instructions of the
disinfectant.
2
1
Wet a new cloth with water and
remove disinfectant. Occasionally
rinse the cloth in running water.
Open the drain.
Rinse all parts with water having
a temperature of 25 °C (77 °F).
18
Allow appropriate
contact time
according to the
instructions of the
disinfectant.
Soak a cloth in disinfectant. Wipe all other contact
areas such as the outside of the bathtub, hand
control and the wheel chassis with the cloth.
14
Spray into the surface of the
overflow outlet.
With water, shower and
rinse the bathtub, lift arm,
transfer chair, the loose
parts and all sides of the
accessories.
08.AZ.00_6EN • 09/2020 • Page 3/3
ArjoHuntleigh AB
Hans Michelsensgatan 10
211 20 Malmö, Sweden
www.arjo.com
Disinfect with spray bottle