Arris VIP7300 User manual
Hereby, ARRIS declares that the radio equipment type VIP7300
is in compliance with Direcve 2014/53/EU. The full text of
the EU declaraon of conformity is available at the following
Internet address: hp://arris.com/consumers/eudoc.
In accordance with Commission Regulaon (EU) 2019/1782,
energy eciency data for the power supply provided with
this product is available here: hps://www.commscope.com/
consumers/psuinfo.
Disabling Wireless: This equipment is dependent on wireless
for primary operaon. To disable wireless disconnect the
product from power. Installation Guide
VIP7300
Set-top box
Caring for the Environment by Recycling
When you see this symbol on an ARRIS product,
do not dispose of the product with residenal
or commercial waste. Some countries or regions
have set up systems to collect and recycle electri-
cal and electronic waste items. Recycling informa-
on can be obtained from the WEEE recycling
secon at www.CommScope.com.
Please recycle product packaging and this
document.
®
Ambient operang
temperature
0 °C to +40 °C
Voltage 100-240 V~,50/60 Hz, 1A max
Power supply unit This Class II product, VIP7300, shall
be powered by the Limited Power
Supply that is provided together
with the product.
Maximum Power
consumpon
12 W
504-xxxxx00
The following table shows the maximum EU RF Output Power:
Frequency Band (GHz) Maximum RF Power (dBm)
2.4 to 2.48 10
5.150 – 5.350* 23
5.470 – 5.725 23
*Indoor use only BE, BG, CZ, DK, DE, EE, IE, EL, ES, FR, HR,
IT, CY, LV, LT, LU, HU, MT, NL, AT, PL, PT, RO, SI, SK, FI, SE, and
UK(NI).
Front panel
LED indicators:
•On: Blue
•Standby: Red
Rear panel
POWER
For connecons to the power
supply included in the package
ETHERNET
For broadband connecon
HDMI
For connecon to your TV
(High and Standard Denion
digital video and digital audio)
OPTICAL
For connecon to your
audio/home theatre system
In the box
VIP7300 HDMI cable Power supply
RCU
EU Compliance is maintained at the following address:
ARRIS Group B.V., Hoogoorddreef 5,
1101 BA Amsterdam-Zuidoost, The Netherlands
© 2022 CommScope, Inc. All rights reserved.
ARRIS and the ARRIS Logo are trademarks of CommScope,
Inc. and/or its aliates. All other trademarks are the
property of their respecve owners.
The terms HDMI, HDMI High-Denion Mulmedia Interface,
and the HDMI Logo are trademarks or registered trademarks
of HDMI Licensing Administrator, Inc.
Manufactured under license from Dolby Laboratories.
Dolby, Dolby Audio, Pro Logic, and the double-D symbol are
trademarks of Dolby Laboratories Licensing Corporaon.
NOTE:
Do not use any power supply other than the
one supplied with the product. Doing so may
cause re or seriously damage your set-top
box.
INSTALLING YOUR SET-TOP BOX
Power outlet
Connect one end of the power
supply to POWER port on your
set-top box and to the power
outlet.
Connect your set-top box to your home
Wi-Fi network.
123
Connect one end of the HDMI cable to
the HDMI port on your set-top box and
the other end to the HDMI connector on
to your TV.
To display a picture from your set-top
box, your TV must be switched to the
correct external input. This is either done
automacally or manually, using a buon
on the TV remote control. See your TV
user’s guide for instrucons.
Insert the baeries into your remote
control.
The remote control will iniate
pairing with your set-top box when
baeries are inserted and any key is
pressed.
4
NOTE:When removing the Ethernet/
LAN cable make sure to rmly press the
underside latching tab on the Ethernet/
LAN cable; to unlock the cable from the
Ethernet/LAN port on the product.
IMPORTANT SAFETY INSTRUCTIONS
• Never place the product on top of or close to any
heat sources such as other electronic devices. Doing
so will reduce lifeme and may cause irreparable
damage or malfuncon. Do not use the product near
water. Note that the ambient temperature must be
below 104° F/40 C. Be sure to maintain necessary
space around the product to allow for proper
venlaon.
• Never use the product outside. The product is
designed to stand on a horizontal surface.
• Do not use any power supply other than the one
supplied with the product. Doing so may cause re or
seriously damage the product.
Federal Communicaon Commission Interference
Statement:This device complies with Part 15 of the
FCC Rules. Operaon is subject to the following two
condions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operaon.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protecon
against harmful interference in a residenal
installaon. This equipment generates, uses and can
radiate radio frequency energy and, if not installed
dierent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV
technician for help.
FCC Cauon: Any changes or modicaons not
expressly approved by the party responsible for
compliance could void the user’s authority to operate
this equipment. This transmier must not be co-
located or operang in conjuncon with any other
antenna or transmier.
Radiaon Exposure Statement:This equipment
complies with FCC radiaon exposure limits set forth
for an uncontrolled environment. This equipment
should be installed and operated with minimum
distance 20cm between the radiator and your body.
and used in accordance with the instrucons,
may cause harmful interference to radio
communicaons. However, there is no guarantee
that interference will not occur in a parcular
installaon. If this equipment does cause harmful
interference to radio or television recepon, which
can be determined by turning the equipment o
and on, the user is encouraged to try to correct
the interference by one of the
following measures.
- Reorient or relocate the receiving antenna.
- Increase the separaon between the equipment
and receiver.
- Connect the equipment into an outlet on a circuit
Alternavely: Connect one end of the
Ethernet cable (not included) to the
Ethernet port on your set-top box and
the other end to your home router.
IC Warning
- English: "
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
- French:"
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement."
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by
Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotopically radiated
power (e.i.r.p.) is not more than that necessary for
successful communication.
Selon les règlements d'Industrie Canada, cet émetteur radio ne peut fonctionner qu'à l'aide d'une antenne d'un type et d'un gain maximal (ou moindre) approuvé pour
l'émetteur par Industrie Canada. Pour réduire les interférences radioélectriques potentielles avec d'autres utilisateurs, le type d'antenne et son gain doivent être choisis
de telle sorte que la puissance équivalente rayonnée (p.i.r.e.) ne soit pas supérieure à celle nécessaire pour une communication réussie.
STATEMENT OF RADIATION EXPOSURE:
This equipment complies with the limites of exposure to IC radiation established for an uncontrolled environment. This equipment must be installed and used with a
minimum of 20cm distance between the radiation source and your body.
DÉCLARATION D'EXPOSITION AUX RADIATIONS:
Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé
avec un minimum de 20cm de distance entre la source de rayonnement et votre corps.
Other Arris Set-top Box manuals
