Artesia AP-100 User manual

EASY ASSEMBLY GUIDE
IF YOU HAVE ANY QUESTIONS OR PROBLEMS
PLEASE CALL OUR TOLLFREE HELPLINE
ASSEMBLY GUIDE
888-998-9848
DO NOT RETURN TO THE STO R E
AP-100 Upright Digital Piano

Legs (2)
1. Begin assembly by attaching the pedal board to the
piano legs. With the pedals facing forward towards the
front of the legs, attach the pedal board using four
Pedal Board Bolts, as shown.
2. Using four Back Panel Screws, and two Back Panel
Bolts, attach the back panel to the stand as shown.
A.
B. C.
D.
E.
F.
G.
H.
I.
J.
K.
L.
M.
N.
1. UNPACKING YOUR NEW DIGITAL PIANO
A Piano Body x1
BLeft Side Leg x1
CRight Side Leg x1
DBack Panel x1
EPedal Board x1
FPedal Board Bolts x4
GPiano Body Bolts x6
HBack Panel Bolts w/ Washers x2
IBack Panel Screws w/ Washers x 4
JMounting Screws x2
KHeadphone Holder x1
LPhillips Screwdriver x1
MPower Supply Cable x1
NUSB Audio Cable x1
Unboxing Your New Artesia Piano
Assembling the Piano Stand
(Fig 2.)
(Fig 2.)
(Fig 1.)
(Fig 1.)

4. Finish attaching the piano to the stand by using the
sixremaining Piano Body Bolts to attach the bottom of
the piano to its stand.
3. Lift the piano onto the stand and slide forwards,
pushing the guide rods on the bottom of the piano into
the slots on the piano legs.
5. Attach the AC Power Cord and Pedal Cable into their
connectors on the bottom of the piano as shown.
6. Turn the Pedal Support Bolt beneath pedals counter-
clockwise until the bolt rmly rests on the oor.
(Fig 4.)
(Fig 5.)
(Fig 5.)
(Fig 6.)
(Fig 6.)
(Fig 3.)
(Fig 3.)
(Fig 4.)
(Fig 4.)
Attaching the Piano Body
Final Set Up

Piano Bench Assembly
If you have any questions about your piano please contact us
toll free at
888-998-9848
Virgin (VMI) is the Parent Company of Artesia Pianos
Virgin Musical Instrument Company
P.O. BOX 2908
LA MESA, CA 91943
[e-mail]
www.virginmusicalinstruments.com
To assemble the bench, insert the threaded leg rod through the metal bracket (located on all four corners
underneath of the padded top). Secure each leg with a locking washer and nut, then tighten with the
wrench provided as shown in the picture below.
Padded Bench
Locking Washer (4)
Wrench
Nut (4)
Leg (4)
Locking Washer
Metal Bracket
Leg Rod
Nut
Assembling the Bench