Ascent Solar XD 48 User manual

90°
USER GUIDE
Collect
Average Performance Best Performance
Store Power
MODEL 800360
Please review the following information before using your Ascent XDTM48 Solar Charger.
Ascent XD48 Solar Charger 4 x Carabiners 4 x Elastic Bands
2 meter Micro-Con-X®
to 7.4 x 5.0mm Dell
connector cable
Solar
Output Port
The Ascent XD48 is designed for outside use to charge high-capacity power banks and other
compatible devices.
Ensure that the panel is angled towards the sun to receive the most direct sunlight.
For device charge times, please visit www.AscentSolar.com.
1. Unfold: Completely unfold the Ascent XD48 Solar Charger to ensure all twelve panels are solar-side
up and exposed to the sun.
2. Connect to Panel: Locate the two-pin connection end of the 2 meter Micro-Con-X®to 7.4 x 5.0mm
Dell connector cable. Plug the two-pin connection end into the solar output port on the solar
charger. Turn locking nut clockwise until it clicks rmly into place.
3. Connect to Device: Locate the barrel connection end on the opposite end of the connector cable.
Plug the barrel connection end into the solar input port on your device.
INCLUDED
HOW IT WORKS
FOR BEST CHARGING PERFORMANCE
Always ensure the panels are folded solar-side in.
FOLDING THE ASCENT XD48

The product carries a 1 year warranty.
For more information:
www.AscentSolar.com
[phone]
[email protected]
• Avoid immersion in water. If unit is immersed, dry immediately with a dry cloth or towel.
• Do not bend or crease the modules except where provided for by the hinges.
• Avoid partially shading modules under load to prevent reduction in power.
• Articially concentrated sunlight (i.e. with a magnifying glass or by other means) should not
be directed onto the modules.
• Do not cut, scratch, or puncture the modules, hinges, or terminal connection box.
• Do not stand on or walk on the modules, hinges, or terminal connection box.
• Do not drop or allow objects to fall onto the modules, hinges, or terminal connection box.
• Do not attempt to open, or otherwise dismantle the terminal connection box.
• Do not leave your personal electronic devices out in sun for extended periods of time.
• Do not fold the panel incorrectly. Follow the folding instructions to prevent long term
damage to the panel.
• Included carabiners are not t for weight bearing activities, such as rock climbing.
Carabiners are intended solely for solar hanging use.
• Solar panel not designed for permanent outdoor installation.
WARRANTY, FAQs, TROUBLESHOOTING & SUPPORT
CAUTIONS & WARNINGS
SPECIFICATIONS
Ascent Solar Technologies, Inc. | 12300 Grant Street, Thornton, CO 80241-3120 USA
171101-2-0
Pmax: 48 Watts unregulated
Isc: 3.0 Amps
Imp: 2.7 Amps
Voc: 24 Volts
Vmp: 18 Volts
3.75 lbs (1.7 kg)
Solar Port
15.4 x 10.2 x 2.4 in (39 x 26 x 6 cm)
-40°F to 185°F (-40°C to 85°C)
-40°F to 185°F (-40°C to 85°C)
CE, FCC
50.8 x 31.1 in (129 x 79 cm)
PV Thickness: 0.08 in (2 mm)
PV + Junction Box Thickness: 1.1 in (27 mm)
Power
Weight
Output
Folded
Operating Temperature
Storage Temperature
Certications
Unfolded
*STC: 1000 W/m2, 25°C module temperature, AM 1.5 spectrum;
power & electrical tolerance not to exceed ±10%.