ASROCK SUSB 3.0 User manual

ASRock USB 3.0 Card Quick GuideASRock USB 3.0 Card Quick Guide
ASRock USB 3.0 Card Quick GuideASRock USB 3.0 Card Quick Guide
ASRock USB 3.0 Card Quick Guide
I. IntroductionI. Introduction
I. IntroductionI. Introduction
I. Introduction
ASRock USB 3.0 Card allows you to enjoy the high speed data transfer rate up to
5.0 Gb/s, which is ten times faster than current USB 2.0 device (480 Mb/s). With
two USB 3.0 ports on ASRock USB 3.0 Card, you can have a more flexible option
to upgrade the USB data transfer rate for your motherboard. Therefore, on this
basis of the advantageous data transfer speed and the facilitating mobile
capability, USB 3.0 may replace other devices to become a trend for external
interface.
II. InstallationII. Installation
II. InstallationII. Installation
II. Installation
Before you install ASRock USB 3.0 Card on your motherboard, please refer to
below steps carefully.
Step 1. InsertASRock USB 3.0 Card into PCIE slot onASRock motherboard. Please
make sure to disconnect power supply before installing or removing
ASRock USB 3.0 Card.
Step 2. Boot your system and install ASRock USB 3.0 Card driver from ASRock
support CD. ASRock USB 3.0 driver is located in the following path of
ASRock support CD:
..\Drivers\USB3.0\NEC\Win7-64_Win7_Vista64_Vista_XP64_XP
(v10170)\NECEL-USB3-Host-Driver-10170-setup.exe
Step 3. Restart your system. Then you can freely enjoy the convenience of
ASRock USB 3.0 Card.
* Whether USB legacy can work depends on the system motherboard BIOS support.
USB 3.0 Ports:
Connect USB 3.0
devices to USB 3.0
ports.
3V_DUAL_POWER Jumper:
Short pin1, pin2 to enable USB Wakeup.
Short pin2, pin3 to disable USB Wakeup
to meet EuP standard.