ASROCK USB 3.1/A+C User manual

ASRock USB 3.1/A+C Installation Guide
Specications
Platform • Size: 3.1-in x 3.2-in, 7.9 cm x 8.1 cm
Controller • ASMedia ASM1142 Controller
PCIE
• PCI Express x4 Connector (x2 lane)
• Compliant with PCI Express 1.1, 2.0 and 3.0 specications
• Supports data rates up to 10 Gbps
• Compliant with x4, x8 or x16 PCI Express Slots
Connector
• 1 x USB 3.1 Type-A Port (Supports ESD Protection (ASRock
Full Spike Protection))
* For charging Type-A USB devices, we suggest using the Type-A
connectors on your motherboard.
• 1 x USB 3.1 Type-C Port (Supports ESD Protection (ASRock
Full Spike Protection))
* is port supports power outputs up to 5V/3A. For charging Type-C
USB devices, the device should support Type-C standards to adjust the
current because it will be dierent in Power On state (3 Amp) and Sleep
state (1 Amp).
* Some Type-C USB devices may only be charged by its own adapter.
OS
• Microso® Windows® 8.1 32-bit / 8.1 64-bit / 8 32-bit / 8 64-
bit / 7 32-bit / 7 64-bit
J1
USB3.1/A+C
PCI Express x4 Connector
(x2 lane)
USB 3.1 Port (Type-A)
USB 3.1 Port (Type-C)
P/N: 15G06X847000AK V1.0
*15G06X847000AK*

Installation Procedure
e ASRock USB 3.1/A+C provides two external USB 3.1 ports which support
transfer rates up to 10 Gbps. Follow the simple steps below to install the ASRock
USB 3.1/A+C.
Step 1
Power o the PC and unplug the power cord. Detach all other cables from the PC.
Step 2
Remove the side panel from the computer case.
*Refer to the documentation that comes with your PC for details.
Step 3
Locate an available x4, x8 or x16 PCI Express slot on your motherboard and remove
its slot bracket. To maximize the performance of ASRock USB 3.1/A+C, it is highly
recommended to insert the card into the PCI Express slots which are provided
directly from the CPU.
*Please refer to the PCIe Chapter of the User's Manual.
Step 4
Align the ASRock USB 3.1/A+C with the PCI Express slot and press down rmly
until it is fully seated in the slot. en secure the card with the slot bracket’s holding
screw.
Step 5
Replace the side panel. Reconnect the power cord and any other cables that were
disconnected.
*Jumper Setup:
Jumper J1 is set to Pin2-3 by default and only allows device charging during S0
(Power On). To enable device charging during S3 (Sleep), S4 (Suspend) or S5 (Power
O) power states, you need to move the jumper cap placed on Pin2-3 (default) to
Pin1-2.
Note: Device charging during S3/S4/S5 also requires the motherboard’s PCIe slot to
provide 1 ampere current of +3VSB power for each port.
*Please install driver for Windows® 7 (32-bit and 64-bit).