Atlantis Quub User manual

Any revisions must first be approved by the product designer. Version: 201806 Revision By: JST
BASE AND WASTE FITTING INSTRUCTIONS
BFK-QUUB-2018
EASY CLEAN WASTE FITTING
Included with this product –BFK-QUUB-2018:
Other equipment required
1 x
White Waste Cover

Broom
1 x
Waste Fitting –40mm Easy Clean

Accurate level
1 x
Waste installation key

Adhesive application / caulking gun
2 x
SturdiBond construction adhesive

Tape measure
1 x
White NG silicone

Levelling compound and associated equipment
(only required for shower base being installed
into a concrete recess)
1 x
Quick Start Guide

1 x
Base fitting instructions (this booklet)

Included with this base package
1 x
Shower Base

1 x
Acrylic Trim –QU-TRIM

The installation process requires the body of the waste fitting to be installed prior to the installation of
the base. This should be undertaken by a qualified plumber.
Atlantis showers are supplied with SturdiBond to adhere the base to the floor substrate. It is
recommended that Gorilla Grip is used if the temperature drops below 5 degrees.

Any revisions must first be approved by the product designer. Version: 201806 Revision By: JST
FLOOR PREPARATION –on any floor type
FIGURE 1
1. Sweep floor free of dust
2. Provide a hole for the waste fitting to a minimum size of 230mm x
230mm, FIGURE 1, in the correct position to suit the shower base.
3. Dry fit the shower base onto the flooring to ensure it is able to be
installed level. The top of the glazing channel(s) and top edges of
the upstands must be level. Re-check that the Waste Body
Assembly is correctly aligned with the centre of the base hole.
Ensure all base rings are supported by flooring.
FIGURE 2
FIGURE 3
NOTE: It is the responsibility of the installer to:
-Ensure the shower base has been installed level, and
-Ensure that the shower base drains sufficiently before the
shower base is adhered to the floor
4. Separate the components of the waste into:
A. the inner ring and waste cup
B. the waste body and body seal
5. Connect the waste body to the pipework, FIGURE 2, ensuring that
the body seal is in the correct position and 25mm below the floor
level, as in FIGURE 2 and 3
25mm lower than floor level
230mm x 230mm
hole in floor

Any revisions must first be approved by the product designer. Version: 201806 Revision By: JST
BASE INSTALLATION
6. Clear floor of all debris and dust
7. Apply supplied construction adhesive liberally to the webbed
support rings
8. Install base in final position, ensuring that it is level
9. The inside face of the upstand must be flush with the inside face
of the wall board.
10. Allow suitable time for the base adhesive to cure.
ACRYLIC TRIM
11. Dry fit 10mm acrylic trim (QU-TRIM) to front face of shower base.
Trim length to suit shower base.
12. Silicone into place using supplied white silicone. Tape and let
silicone cure.
WASTE CONNECTION
13. Insert the inner ring through the waste outlet in the shower
base and screw the inner ring into the waste body. Hand tighten
using the installation key.
14. Place the waste cup and Easy Clean component (not pictured)
into position within the inner ring.
IMPORTANT NOTES
-If tiling the walls the wall glazing channels must be fitted to the wall after waterproofing, prior to tiling.
-Ensure the shower base has been installed level.